Bergen 180 Gloss/Mirror doors
Assembly Instructions- Please keep for future reference
DR825088
412/7305
417/9463
Gloss/Mirror doors
Dimensions
Width - 180cm
Depth - 6.7cm
Height - 195.2cm
Tip : To prevent damage,
we recommend that you
build your unit on the
carton(s) it was packed in.
412/7305 WHITE GLOSS- MIRROR
417/9463 CASH GLOSS- MIRROR
Dimensions
Important – Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, please visit: www.argos-support.co.uk
or email: Help@ClickSpares.co.uk (quoting your original order number)
Alternatively, call the Spares Helpline on: 0370 112 1928
For any other queries please contact the Customer Helpline on: 0345 640 2020
Issue 1 - 03/07/15
Safety and Care Advice
Important – Please read these instructions fully before starting assembly
• Check you have all the
components and tools listed on
pages 2 and 3.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
Care and maintenance
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• Do not stand or put weight on
the product, this could cause
damage.
• Assemble the item as close
to its final position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• Parts of the assembly will be
easier with 2 people.
• From time to time check that
there are no loose screws on
this unit.
•To reduce the
likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
• Dispose of all packaging
carefully and responsibly.
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal centre.
Handy Hints
• Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the bolts
• Regularly check and ensure
tightend properly.
Note: if required the next
page can be cut out and used
as reference throughout the
assembly. Keep this page with
these instructions for future
reference.
2
Components - Panels
For damaged or missing parts, please visit:
www.argos-support.co.uk or email: Help@ClickSpares.co.uk
Please check you have all the panels listed below
Cabinet supplied separately
249/4834
248/6921
226/8730
Segment x2
1
(91.5 x 65cm)
P3355
Mirror-Segment x2
3
(91.5 x 65cm)
PS3335
132/3384
Segment middle x1
2
(91.5 x 65.1cm)
P3356
Mirror-Segment middle x1
4
(91.5 x 65.1cm)
PS3274
3
For damaged or missing parts, please visit:
Components - Fittings
www.argos-support.co.uk or email: Help@ClickSpares.co.uk
Please check you have all the fittings listed below
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.
D
Screw x 72 (4x12.5mm)
S
Door handle x 3 (1951mm)
AC
FK1309
PM1652B
ZF9997L
E
Plug, Nylon x 32
T
Brush x 3 (1951mm)
A
(5x9mm)
FK1082
PM1652C
O
Connecting plate x 8
U
Door trim x 1 (1951mm)
AE
Spacer x 1
AI
FK1236
PM1652D
ZF9997F
ZF9997C
Screw x 33 (4x15mm)
AJ
Back guide part x 2
ZF9998D
AK
Sliding door connecting plate x 2
Tools required
Phillips screwdriver
(medium & large)
Drill
Flatblade screwdriver
(medium)
Piercer
(small)
Spirit level
5mm Suitable drill bit
Setsquare
Ruler - Use this ruler to help correctly identify the screws
ZF9997B
Stairs
Front guide part x 2
AL
ZF9997A
Sliding door connecting bracket x 2
Small
hammer
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
0 1 2 3 4 5 6
Ruler/tape
measure
Scissors
Eye protection
(when using a
hammer or drill)
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100
4
105
110 115 120 125 130 135 140 145 150 155 160 165 170