Hydrotech 785 Quick Setup Manual

Page 1

785 Valve Carbon Filter Quick Set Up Manual

Step 1 – Inspection

Check to make sure you got everything supplied by factory and there is no visible or concealed damage. In case of missing items, please contact customer service immediately and have the Product Serial # handy. (Product Serial # can be found at the back of the control valve, see below)

The items you will expect are:

1. Tank with Carbon Media loaded

2. Control Valve

3. Parts Kit

Product Serial #

3. Parts Kit

3/4” Elbow Fitting X 2

1” Straight Fitting X 2

1. Tank with Softener

Media loaded

Spill Cap

D-Tube

Set of Injectors

Grease Packet

2. Control Valve

Brine Elbow

Bypass Tool

Transformer

Bypass Test Port Clip X 2

Drain Hose Fitting

Drain Clip

Bypass

Bypass Cllips X 2

Upper Basket/ Strainer

Brine line Plug ((used for Filters))

Grease port Orings using brush (not included) or your finger (Make sure to wear protective gloves)

Step 2 – Installing Valve to the Tank

Select a Installation location and make sure there is access to 110V power outlet and drain line. Lube the bottom Valve Orings with the grease supplied, Attach the Upper Basket. Unscrew the spill cap. Carefully Slide the D-Tube inside the Valve and Screw the Valve inside the Tank such that the power cord doesnt get caught between the valve and the tank. Make sure the D-Tube slides inside the valve.

Set of Washers

Unscrew Spill Cap

D-Tube

CAUTION: Make sure the power cord of the valve doesnt get caught between the threads

Attach Upper Basket

Page 2

Step 3 – Install Drain Line Washer in the Valve Step 4 – Plug Brine Line of the Valve

'

Swap this washer with the correct one

Hose Barb

Add Brine Plug and Oring

Remove Clips

Replace Drain Washer as per Above For 1 CF - Insert 4 GPM (#6) For 1.5 CF - Insert 5 GPM (#A)

Step 5 – Power and Program Valve and Congure to Filter

Press Up and Down Button for 5 seconds

Select B.W. Filter using Up/Down Buttons- Press Manual Regen Button

Set Backwash to 10 minutes using Up/Down Buttons. Press Manual Regen Button

Set Rinse to 5 minutes using Up/Down Buttons. Press Manual Regen Button

Key Pad Setting

SETTINGS This function is to enter the basic set up information required at the time of installation.

MANUAL This function is to initiate an immediate or delayed manual REGEN regeneration.

DOWN / Increase or decrease the value of the settings while in the UP programming mode.

6(77,1*60$18$/

5(*(1

2:1

VALVE MODE

B. W. Filter

Press Manual Regen Key

BACKWASH

10 Minutes

Press Manual Regen Key

RINSE

5 Minutes

PROGRAMMING

COMPLETE

Remove Clip

Step 6 – Set User Programming

Settings Press SETTINGS key

(3 SECONDS / BEEP) and use Up/Down Buttons to Change the Value

TIME OF DAY

12:01 PM

Press SETTINGS key

YEAR

2016

Press SETTINGS key

MONTH

AUGUST

Press SETTINGS key

DAY

Press SETTINGS key

REGEN DAYS

Press SETTINGS key

PROGRAMMING

3 Days

GALLONS

OFF

REGEN TIME

12:00 AM

COMPLETE

TOLL-FREE: 1-877-288-9888

Regina, SK • Cambridge, ON • Carmel, IN • Fridley, MN • Phoenix, AZ

www.hydrotechwater.com

Follow the Instruction Manual to Complete the Installation of the Product

55229 05/16