Hydro systems PROGRAM 3, 26410-000-100, 26410-000-110, 26410-002-110, 26410-002-100 Operating Instructions Manual

TWO BUTTON CONTROL WITH LCD

OPERATING INSTRUCTIONS

Your whirlpool bathtub has been equipped with Electronic Controls to provide

features that allow you to customize your bathing experience to your individual

preference. Please familiarize yourself with the features and operating

instructions below in order to maximize the enjoyment you receive from your

bath. These operating instructions should be used in conjunction with the other

instructions and warnings provided with your whirlpool bathtub in order to fully

understand and safely utilize the bathtub.

Control Features: Pump, Neck Jet

TABLE OF CONTENTS

1. OPERATING INSTRUCTIONS

• MAIN MENU

• PUMP FUNCTIONS

• TEMP SETTINGS

• TIMER SETTINGS

• NECK JET FUNCTIONS

2. TROUBLESHOOTING & FAQ

PROGRAM 3

26410-000-100
26410-002-110
26410-000-110
26410-002-100

0517ab

Function

Key

Selection

Key

WWW.HYDROSYSTEM.COM

1. OPERATING INSTRUCTIONS

FUNCTION KEY

• Cycle between
Sub-Menus

1. Power On (Activate System)

a. Press and hold Selection Key to power up controller and activate the

system. Display will cycle through Temp and Water Level at startup.

NOTE: If water level is too low, system will not activate and display will

show “low water level” icon.

b. Press and hold Selection Key once to power OFF.

2. Pump Functions

a. Press the Function Key to cycle to Pump menu.

b. Press the Selection Key to toggle Pump ON/OFF.

3. Temperature Settings

a. To change temp from °C to °F, press and hold the Function Key.

SELECTION KEY

• Power On/OFF

• Toggle Options
in Sub-Menus

LCD DISPLAY: POWER ON

WATER LEVEL

LCD DISPLAY: PUMP

2-A

LCD DISPLAY: TEMPERATURE

TEMP

2-B

4. Timer Functions

a. Press the Function Key to cycle to the Timer menu.

b. Press the Selection Key to cycle ON. The Timer default is 20 minute

and can be adjusted up to 60 minutes in five minute increments.

5. Neck Jet Function

a. Press the Function Key for the Neck Jets menu. Will display “N” for

neck jets.

b. To adjust the setting, press Selection Key. Jets have ve dierent

pattern settings:

i. 0 = OFF

ii. 1 = Constant ON

iii. 2 = 0.5 second jet sequence pattern

iv. 3 = 1.0 second jet sequence pattern

v. 4 = 1.5 second jet sequence pattern

3-A3-A

LCD DISPLAY: TIMER

LCD DISPLAY:

NECK

NECK/PILLOW JET DISPLAY

2