Hydro-Force M1, M2 Owner's Manual

Multi-Sprayer

™

•Carpet & Upholstery
Pre & After Sprays

•Ceiling Cleaning

•Janitorial Sprays

•Carpet Restoration
Applications

Ideal For:

Disinfectants, Deo-

Cleaners, Spotting
Agents, Insecticides,
Garden Agents & Fer­tilizers, Cleans Ducts,
Ovens & Siding

Also Sprays:

OWNERS MANUAL

M1 M2

For Parts & Service Call:

www.multi-sprayer.com

(Now also available in cordless rechargeable models)

TO REMOVE PUMP

A. Remove nylon tabs by tapping out from
inside of solution container compartment

B. Remove bottom plate to access pump.

INTRODUCTION

The Multi-Sprayer replaces pump-up sprayers.

The Multi-Sprayer is a tough, compact and versatile electric
sprayer, equipped with a SOLVENT COMPATIBLE VITON
PUMP. It was designed to be easily transported to the job
taking up limited space. On the job, its 20 foot electric cord
and 10 foot spray hose allow you to cover a large area from
each electric receptical.

TWO MODELS, THE M1 AND M2

Common features of the two models are:

•Tough Polyethylene Case

•2 Gallon Quick Change Container Capability

•115 Volt, 50 psi Pump (230 Volt Available)

•20 Foot Electric Cord & 10 Foot Spray Hose

•Pump is Solvent Compatible, Viton Seals

•Spray Trigger Has Viton Seal; also QC

•One Year Warranty Parts and Labor

M1 FEATURES

•2 Foot Wand with 8004 V-jet Nozzle

•Weight 11 Pounds Empty

M2 FEATURES

•2 Foot Wand with 8004 T-Jet with a Check Valve/

Strainer

•Extra 50015 T-Jet Tip for Upholstery with a Check
Valve/Strainer

•Weight 12 Pounds Empty

SAFETY PROCEDURES

•RISK OF EXPLOSION--DO NOT SPRAY COM-
BUSTIBLE FLUIDS

•PLUG INTO 115-120 VOLT 50/60 CYCLE
GROUNDED 3-PRONG RECEPTACLE

Page 2

GETTING STARTED

Slant your 2 gallon container of solution into the Multi-

out, connect the male/female cap quick connect system.
Then push the container into the Multi-Sprayer. To remove
container, push the silver tab on the female quick connect tip
out of container and remove.

Plug in, turn on switch and squeeze trigger to spray.

IF YOU HAVE MODEL M2...

1. Remove the 2 foot carpet wand or the upholstery tip at the
quick connect.

2. Squeeze the trigger, allowing the liquid to advance to near
the trigger.

3. Re-connect the 2 foot carpet wand or upholstery tip and

starting, but stop drips after spraying.

MAINTENANCE

At the end of the work period a mild detergent solution, fol­lowed by fresh water, should be sprayed to clean the pump
and hose. When switching between water based and solvent

case cleans easily with a mild detergent and retains its luster
with application of a plastic/vinyl product.

Your Multi-Sprayer carries a one year parts and labor war­ranty. The date of manufacture is stamped on the serial

plate. Keep your receipt for exact date of ownership for

warranty purposes. FREEZING CAN DAMAGE the Multi­Sprayer and is not covered by the warranty. Consult the
Chemical Guide available from your distributor or manufac­turer for chemical compatibility. Chemical damage to the
pump is not covered by the warranty.

GETTING STARTED

Page 3