Hydro Doors Digi One Installation Instructions Manual

Types of Doors that can be automated using the digi.one:

• Sectional overhead doors, single/double, steel or timber.

• Tip – up doors, steel or timber.

Page 1

Rail

Carriage

Saddles

Bracket

Cross

Door Bracket

1. Features

Microprocessor based control system
One button to open, close and stop
Bright LED courtesy light, with a 3 minute time-out
Easily adjustable operating force/obstacle sensing
Supports Safety Beams
Optional back-up battery
Auto-close feature
24V DC Motor provides superior power to weight, giving quiet, smooth operation with soft starting and stopping
Protected against overload and over-heating
Reliable chain-drive
Sturdy steel Rail
LED Display – simplifies function programming
Security – is ensured by the use of code-hopping technology
Manual Over-ride – a simple release allows the door to be operated by hand
Options – Safety Beams, back-up battery, wall button and Auto-close

2. Technical Specifications

Power Input 220VAC +10% 50~60Hz Receiver Frequency 433.92MHz

Motor 24VDC Decoding Rolling Code
Working Temp >-20C, <+50C Courtesy Lamp LED
Relative Humidity < = 90% Courtesy Lamp Time 3 minutes

Operating Force 1000N Fuse 2,5A 250V

3. Contents of the box

Tapered

Rectangular

Connecting Arms

Door Condition:

For successful automation, a door should be in good working condition, i.e. it should be possible to open and close easily with
one hand, be correctly sprung and run smoothly without sticking or binding. Torsion springs should be greased. Tracks should
be well secured with correct clearances and be clean and free of grime. Badly worn hinges, rollers and bushings should be
repaired or replaced. Remove all unnecessary ropes, brackets, levers, etc.
Caution! Garage doors, door springs, cables, pulleys, brackets and hardware are under extreme force and can cause serious
personal injury.
Note! Most complaints of unsatisfactory garage door operation can be traced to problems with the door itself. The digi.one is
not intended to correct any problems that are caused by an unbalanced or binding door. When operated manually, a properly
balanced door will remain stationary, at any point of its travel, while being supported entirely by its springs.

For optimum reliability and lifespan of your digi.one operator, have your garage door serviced regularly.