Hydra-Cell A03-130-1200 Operating Instructions Manual

Hydra-Cell Vacuum
Priming Kit

Instructions

• Numbers in parenthesis ( ) refer to parts shown on back page

Hydra-Cell Vacuum Priming Kit

Part Number A03-130-1200

The Hydra-Cell Vacuum Priming Kit allows for a convenient way of removing air from behind the diaphragms. It is applicable
to all Hydra-Cell pumps.

Hydraulic priming, a requirement af ter diaphragm replacement, is achieved by attaching the assembly to the pump housing
through the oil cap and pulling a vacuum.

Priming can be accomplished while the pump is turned off, but remaining in place.

Operating Instructions

After replacing Hydra-Cell Pump diaphragms or if the loss of
hydraulic prime is suspected, use the priming assembly to
perform the following steps:

1. Ensure pump is off.

Warning: Personal injury or pump damage can
occur if pump is not turned off.

2. Remove Oil Cap from Hydra-Cell Pump

3. Install Oil Cap (8) with Oil Bottle (6) on Hydra-Cell Pump
reservoir.

4. The Hand Vacuum Pump (1) has two positions: Vacuum and
Pressure. Set hand pump to Vacuum position (arrow down).

Vacuum Position

(Arrow Down)

Oil Bottle (6)

5. Position the Rotating Gauge as convenient. Hand operate
the pump (1) until 25 in. HG is indicated on the gauge.

Note: If the oil bottle (6) starts to fill up with oil, release
the vacuum with the lever at the bottom of the hand pump
and start over (some oil may need to be removed from
the reservoir).

5. Hold vacuum for 15 minutes.

6. Release vacuum with the lever at the bottom of the pump.

7. Remove Oil Cap with Oil Bottle on Hydra-Cell Pump
reservoir.

8. Add oil as necessary.

9. Replace Oil Cap from Hydra-Cell Pump.

10. Clean the Hydra-Cell Vacuum Priming Kit after each use.

Rotating
Gauge

Hand Vacuum
Pump (1)

Oil Cap (8)

Reservoir

United States: [phone] Fax [phone]

United Kingdom: [phone] Fax [phone]

Hydra-Cell Pump

W0548

Instant Information: www.hydra-cell.com

A03-130 - 9 900 6 /2013

3

5

6

2

1

8

7

4

W0549

Hydra-Cell Vacuum Priming Kit - Parts

Hydra-Cell Vacuum Priming Kit

Part Number A03-130-1200

Ref. Quantity/
No. Part Number Description Kit

1 A03-130-1201 Hand Vacuum Pump 1

2 Part of Item 1 1/4“ ID Diameter Tube 1

3 A03-130-1202 Hose Barb, 1/4” Non Valved 1
Elbow, Coupling Insert

4 A03-130-1203 Coupling Body , Non Valved, 1
1/4” NPT

5 A03-130-1204 Adapter, 7/16-20 UNF 2A x 1
1/4-18 UNF 2B

6 D12-116-2220 Bottle, Oil Reservoir, 4 oz. 1

7 103-011 Bushing, 1/4” FNPT x 3/8” MNPT 1

8 D10-039-2311 Oil Cap, 3/8” FNPT 1

WANNER ENGINEERING, INC.

1204 Chestnut Avenue, Minneapolis, MN 55403
TEL: [phone] FAX: [phone]
TOLL-FREE FAX [US only]: [phone]

www.hydra-cell.com
email: [e-mail]

© 2013 Wanner Engineering, Inc. Printed in USA

A03-130 - 9 900 6 /2013