Product Instruction Manual
Scirocco
SC2000Y, SC2000YM, SC2000YMT
Convector heater
This product is only suitable for well insulated spaces
or occasional use
V18.3,5
Thank you for purchasing the Scirocco convector heater. The SC2000Y
and SC2000YM standard
convectors come complete with thermostat and
three heat settings; the SC2000YMT model also includes a 24hr timer. The
Scirocco convector heater is ideal for portable heating applications in the
home and office environment. Please read and understand these
instructions before commencing assembly and use, and leave them with
the user when assembly is complete.
1. Important safety points
Only connect the unit to a single-phase supply with a mains voltage as specified
on the rating plate.
Do not carry the appliance by the supply cord.
The supply cord cannot be replaced by the user. If the cord is damaged the
appliance should be returned to the manufacturer or an authorised service agent
for replacement.
Always keep the outlet and inlet grilles clean.
Do not cover the inlet or outlet as it may cause overheating.
Children of less than 3 years should be kept away unless continuously
supervised.
Children aged from 3 years and less than 8 years shall only switch on/off the
appliance provided it has been placed or installed in its intended normal
operating position and they have been given supervision or instruction
concerning use of the appliance in safe way and understand the hazards
involved. Children aged from 3 years and less than 8 years shall not plug in,
regulate and clean the appliance or perform user maintenance.
Do not use this heater in the immediate surroundings of a bath, a shower or
a swimming pool.
2
2. Installation
Do not use the heater on a carpet with a deep pile.
Do not locate beneath a shelf or similar protrusion.
Do not position near any combustible materials, curtains or other furnishings.
The supplied feet must be fitted prior to operation.
Assembly
•
Holes are provided at the base of the heater.
Select the two holes (on opposite corners)
as shown in the diagram.
•
Align the holes in the feet with those on the
base of the heater and attach using the small
self-tapping screws provided.
3
3. Electrical connection
1
2
3
This heater is intended solely as a portable appliance; only operate using the power
cord and 13 amp plug supplied.
If the plug needs changing, make the connections as:
•
Brown / Red: L
•
Blue / Black: N
•
Green / Yellow: E
4. Operation
Ensure the supply cable is fully uncoiled when in use.
Ensure the supply cable is not in contact with the main body of the heater during
operation as it may become very hot.
•
To turn on the appliance, select the desired power setting.
1 = 750W
2 = 1250W
1&2 = 2000W
• Turn the thermostat to max (fully clockwise). When
the
room reaches the desired comfort level, adjust
the thermostat down (anti-clockwise) until a click is
heard and the lights on the power switches turn off.
The heater will now maintain the current
temperature. Due to the mechanical nature of the
thermostat, temperature levels may vary by a few
degrees on each heating cycle.
• It is advised the lowest adequate heat setting is
4
selected to maintain the desired level of comfort.
Timer feature – SC2000YMT model only
1
24
23
22
21
20
19
18
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
19
•
To set the current time on the 24hr segment timer, twist the outer ring until the
pointer is aligned with the correct time.
•
If the heater is unplugged the timer will stop keeping time and it must be set again.
•
The slide switch on the timer offers three settings:
I = On permanently (non-timed).
Clock = Timer regulated operation.
O = Off permanently (non-timed).
•
To set the times of operation, pull out each segment for ON or push back in for OFF.
Each segment represents 15 minute slots.
Segment
Slide Switch
Pointer
5. Maintenance
Always isolate the appliance from the power supply prior to the commencement
of any maintenance.
Do not use abrasive chemicals or materials.
•
•
Clean the exterior with a damp cloth.
Remove debris from the inlet and outlet at regular intervals using a soft brush
or vacuum cleaner.
5
6. Specifications
W
Voltage 230v~50Hz
Power 750-2000W
Model Height (mm) Width(mm) Depth(mm) Weight(kg)
SC2000Y
SC2000YM 385
SC2000YMT 385
H
420 580 200 3.0
530 200 2.5
530 200 2.5
D
6
Model identifier(s): SC2000Y, SC2000YM, SC2000YMT
Item Symbol Value Unit Item Unit
Heat output Type of heat input, for electric storage local
Nominal heat outp ut Pnom 2.0 kW
Minimal heat outpu t
(indicative)
Maximum continuous
heat output
Auxiliary electricity consumption
At nominal heat
output
At minimum heat
output
In standby mode elS B 0 kW
Contact details : Hyco Manufacturing Ltd, Cast leford WF10 5NR www.hyco.co.uk
Pmin 0.75 kW
Pmax,
c
elmax 0 kW
elmin 0 kW
2.0 kW
space heaters (s elect one)
manual heat charg e control with
integrated thermostat
manual heat charg e control with
room and/or outdoor
temperature feedbac k
electronic heat c harge control
with room and/or outdoor
temperature feedbac k
fan assisted heat o utput
Type of heat output/ room temperature
control (selec t one)
single stage heat o utput and no
room temperature control
two or more manual stages, no
room temperature control
with mechanic thermostat room
temperature control
with electronic thermostat room
temperature control
electronic room temperature
control plus day timer
electronic room temperature
control plus w eek timer
Other control options (multiple selections
possible)
room temperature control, with
presence detecti on
room temperature control, with
open window detecti on
with distance contro l option No
with adaptive start c ontrol No
with working time limitation No
with black bulb sensor No
No
No
No
No
No
No
Yes
No
No
No
No
No
7. Guarantee and service policy
This product is guaranteed against faulty materials and manufacture for a period of one
year from the date of purchase. Hyco will in its sole discretion replace, repair or refund
any faulty unit. Incorrect installation and failure to follow correct operating instructions
are excluded. Consequential costs such as labour charges or damage to surroundings
are expressly excluded.
7
INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH THE
EUROPEAN DIRECTIVE 20
12/19/EU.
At the end of its working life this equipment must not be disposed of as household
waste. It must be taken to a local authority waste collection centre or to a dealer
providing this service. Disposing of electrical and electronic equipment separately
enables its components to be recovered and recycled to obtain significant savings in
energy and resources. In order to underline the duty to dispose of this equipment
separately, the product is marked with a crossed out dustbin.
Hyco Manufacturing Ltd
Normandy Court
Express Way
Castleford, WF10 5NR
T 01924 225 200
F 01924 225 210
E sales@hyco.co.uk
hyco.co.uk
Loading...