Hussmann NIM, NIM-4, NIM-6 Installation & Operation Manual

SERIES NIM

Low Temperature
Merchandisers

PLEASE READ THIS MANUAL BEFORE USING THE PRODUCT

Operation Manual

Hussmann Monterrey, Mexico

Carretera Mexico-Laredo KM. 1009

Cienga de Flores, Nuevo Leon 65550

Mexico
Phone: [phone]
Fax: [phone]

Installation &

P/N 2402195

NIM-6
January 2003

TABLE OF CONTENTS

Page

Introduction 1
Inspection 1
Location 1
Clearance 1
Shipping Braces 1
Placement of Doors 1
Leveling of the Cabinet 2
Sealing Splashguard to Floor 2
Grills 2
Drain 3
Tempered Glass Doors 3
Display Pan 3
Air Distribution 3
Electric connections 4
Serial plate 4
Control of temperature 4
Defrost time Clock 4
Maintenance 5
Technical Data Sheets 5

IMPORTANT
KEEP IN STORE FOR FUTURE REFERENCE

INTRODUCTION

The NIM – 6 and NIM-4 are low temperature self-contained cabinets, designed for pre-packaged frozen foods
or Novelty Ice Cream products.

Design features include self closing glass doors, CFC Free insulating foam, low rail height for ease of access,
and a balanced refrigeration system for optimum energy savings.

INSPECTION

a) General
All the cabinets should be thoroughly examined to detect damages before and during unloading from the
delivering carrier.

This cabinet has been inspected carefully at our factory. Any claim for loss or damage must be made to the
carrier. The carrier will provide any necessary inspection reports and/or claim forms.

b) Apparent Loss or Damage

If there is an obvious loss or damage, it must be noted on the freight bill or express receipt and signed by the
carrier’s agent; otherwise, carrier may refuse claim.

c) Concealed Loss or Damage

When loss or damage is not apparent until after the cabinets is uncrated, retain all packing materials and submit
a written request to the carrier for inspection, within 5 days.

LOCATION
Avoid locating where the light of the sun is direct, where air conditioning grills exist, or near electric fans,
doors, and open windows, that can create currents of air around these cabinets.

CLEARANCE

To prevent sweating on the exterior surfaces, there must be a minimum clearance of 4in. (102mm) between
merchandisers, other fixtures and store walls.

SHIPPING BRACES

Move the cabinet as close as possible to its permanent location and then remove all packaging. Check for
damage before discarding packaging. Remove all separately packed accessories such and kits.

PLACEMENT OF DOORS

The case doors are packed in cabinet. Install them in the following manner:

1. Install the left door first (interior).

2. Hook the door in the right interior upper corner with the hooks of automatic closing mechanism and push
toward the right. (fig.1)

3. Place the top in the interior upper rail leaving at an angle (fig 2.)

4. To align, push up and in to the back bottom rail (fig. 3)

5. Place the right or external door in the same way