Hussmann FHM, FHMG, FHMSA, FHMSGA, MHF Parts List
...
MHF, MHFH MHFG, MHFGH
FHM & FHMS FHMG & FHMSG
1. 2 2
1
/
2 x
1
/
2 x 120-in. Gasket
2. 1 1 Front Panel Joint Trim
3. 1 1 Rubrail Joint Trim
4. 1 1 Fascia Joint Trim
5. 1* 1* Ambient Plenum Joint Trim
6. 6 6
3
/
8-16 x 1
1
/
4 Cap Screw
7. 12 12
3
/8 Flat Washer
8. 6 6
3
/8-16 Hex Nut
9. 10 8 #8 x 1/2 Truss Head Sheet Metal Screw
10. – 1 #10-24 x 2
1
/4 Machine Screw
11. – 1 #10-24 Wing Nut
12. 1 1 Butyl Tape (
1
/
16 x 2 x 49-in.)
13. 1** 1** Light Channel Retainer
* Supplied with FHM, FHMS, FHMG & FHMGS models only.
** Supplied with MHF, MHFH, MHFG & MHFGH models only.
P/N 0316517D
November, 1991
FHM, FHMG, FHMS, FHMSG
MHF, MHFG, MHFH & MHFGH
Joint Kit
PARTS LIST
Item Quantity Description
®
P/N 0316517D 2
Installation Instructions
STEP 1. Apply the Gasket 1 around the perimeter of the merchandiser as shown
and as follows:
a. Apply the gasket to metal surfaces only.
b. Recess the gasket approximately
1
/8-inch in from the exterior surfaces.
c. Avoid splicing the gasket on horizontal runs.
d. Do not stretch gasket around corners.
e. Remove the paper backing after gasket is applied.
STEP 2. After the first merchandiser has been leveled in its permanent location,
move the joining merchandiser firmly against the first to compress the
gasket for a good seal.
STEP 3. Fasten the two merchandisers together through their end frame joining
holes with Cap Screws 6 , Flat Washers 7 , and Hex Nuts 8 .
CAUTION:
DO NOT USE THE CAP SCREWS
TO PULL THE MERCHANDISERS TOGETHER
.
DAMAGE TO THE MERCHANDISER AND
END FRAME DISTORTION
CAN RESULT
.
STEP 4. Install the Front Panel Joint Trim 2 centered over the merchandiser joint
and fasten using Screws 9 .
STEP 5. Install Rubrail Joint Trim 3 as follows:
Merchandisers W
ithout Glass Fronts
Place rubrail joint trim centered over merchandiser joint. Drill pilot
holes into rubrail and fasten trim with Screws 9 .
Merchandisers W
ith Glass Fronts
Place rubrail joint trim centered over merchandiser joint.
Insert Screw 10 through hole in trim and fasten in place
with Wing Nut 11 .
Loading...