Hussmann MAXI-140 Owner's Manual
MAXI-140
Owner’s Manual
P/N 0512888_A
01 October 2009
Beer
Merchandiser
®
®
P/N0512888A
Shown with Optional Leg kit
These merchandisers are manufactured to meet ANSI / National Sanitation Foundation (NSF®) Standard #7 Type II
requirements. Proper installation is required to maintain certification. Near the serial plate, each case carries a label
identifying the type of application for which the case was certified.
ANSI/NSF-7 Type II – Display Refrigerator / Freezer ( Beverage Cooler)
Intended for 80°F / 55%RH Ambient Application
This equipment is intended for the storage and display of
nonpotentially hazardous, bottled or canned products only.
Copyright Notice
Hussmann and Safe-NET are trademarks of Hussmann Corporation
EPH
©2009 HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
U.S. & CANADA 1-800-922-1919 • MEXICO 1-800-522-1900 • WWW.HUSSMANN.COM
SAFETY FIRST!
Before installing, read and understand the
operating manual. Any damage caused by not
following directions given in this manual is outof-warranty.
Contact
To request technical assistance with your
Hussmann Beer Merchandiser, or to place a
service call, please phone Hussmann’s CALL
CENTER • U.S. or Canada 1-800-922-1919 •
Mexico 1-800-522-1900.
LOCATION
Hussmann Beer Merchandisers are designed
for a protected environment, out of direct sun
or rain. Placing the unit near heat sources
(ovens, grills, etc.) or in direct sun will adversely affect performance. Unusual ambient
conditions can be handled by changing settings
in the Safe-NET controller. Temperatures of
80°F (27°C) and less than 55% R.H. are considered normal ambient conditions.
The merchandiser will not operate properly
in environments of extreme temperature and
humidity [above 80°F (27°C) and 55% relative
humidity]. Performance issues resulting from
poor local conditions are out-of-warranty.
The merchandiser must have a minimum 5-inch
(13 cm) ventilation space at the back, on each
side, and below the door in front. Top must be
open.
1
P/N 0512888_A
01 October 2009
MAXI-140
Hussmann Beer Merchandiser
™
MAXI-140
™
MAXI-140
™
MAXI-140
™
MAXI-140MAXI-140
To reduce the risk of fire, electrical shock or
injury when using your Hussmann Beer
Merchandiser:
• Always use a dedicated circuit with the
Amperage stated on the unit.
• Plug into an outlet designed for the plug.
• Do not use an adapter.
• Do not overload the circuit.
• Disconnect power before servicing.
• Replace any damaged power cord.
• Never turn off by pulling on the power cord.
• Unit must have electrical ground at all times.
• Never connect the ground wire directly to the
neutral wire or connect to gas, water,
telephone, drain pipe, lightning rod, etc.
• Do not damage the refrigeration system.
• Do not use any mechanical device or other
means to speed the defrost process, except
as recommended by the manufacturer.
• Unplug the Hussmann Beer Merchandiser
before cleaning.
• Do not store or use toxic or dangerous
chemical products inside the case.
• Do not use electrical devices in the
Hussmann Beer Merchandiser unless
recommended by the manufacturer.
• Use two or more people to move a unit.
• Keep packing materials away from children.
CAUTION
!
We reserve the right to change or revise specifications and product design in
connection with any feature of our products. Such changes do not entitle the
buyer to corresponding changes, improvements, additions or replacements
for equipment previously sold or shipped.
OPEN
N
OTHING ABOVE
5-inch (13 cm) Required Ventilation Minimum
Condensation may form on external parts
when the merchandiser is used in high relative
humidity. Use a soft cloth to remove moisture.
The floor or counter must be flat to facilitate
leveling and to avoid problems with door sealing or abnormal noises. The floor, or counter,
must support the weight of a fully loaded
Hussmann Beer Merchandiser. A fully loaded
MAXI-140 weighs about 210 lb (95-kg).
INSPECTION
All equipment should be thoroughly examined
for shipping damage before and during the
unloading.
Each Hussmann Beer Merchandiser is carefully
inspected at our factory. Any claim for loss or
damage must be made to the carrier. The
carrier will provide any necessary inspection
reports and/or claim forms.
Apparent Loss Or Damage
If there is an obvious loss or damage, it must
be noted on the freight bill or express receipt
and signed by the carrier’s agent; otherwise,
carrier may refuse claim.
Concealed Loss Or Damage
When loss or damage is not apparent until after
equipment is uncrated, retain all packing materials and submit a written request to the carrier
for inspection, within 15 days.
UNCRATE
Use the appropriate equipment to safely lift and
move the Hussmann Beer Merchandiser to the
preferred location in your business.
Carefully remove the shipping box. Avoid
scratching the Hussmann Beer Merchandiser.
Recycle packing materials whenever possible.
Remove Shipping Legs so the MAXI-140
merchandiser base can be sealed to counter.
After leveling, use field-supplied FDA foodgrade silicone sealant* to seal the gap between
the base of the MAXI-140 and the countertop.
2
P/N 0512888_A
01 October 2009
MAXI-140
©2009 HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
U.S. & CANADA 1-800-922-1919 • MEXICO 1-800-522-1900 • WWW.HUSSMANN.COM
IMPORTANT:
The MAXI-140 Beer Merchandiser must
remain upright at all times. Do not tilt more
than 30 degrees from vertical at any time.
Remove Shipping Legs
Front and Back
* Examples of FDA food grade silicone sealant:
Permatex Inc.
Silicone RTV Sealant for Food Zone
Henkel Loctite Corp.
RTV Silicone Adhesive Sealants for Food Zone,
"Loctite Superflex"
Silicone Sealant for Food Zone,
"Loctite Silatech"
General Electric Co.
RTV Silicone Rubber Adhesive Sealant for Food Zone,
"RTV 102, RTV 103, RTV 108, RTV 112, and others"
DOW Corning Corp.
100% Silicone Sealant for Food Zone,
"Dow Corning Commercial Grade"
Industrial Grade Silicone for Food Zone,
"Dow Corning 700"
. RTV Silicone Sealant for Food Zone,
"Dow Corning HVAC/R"
©2009 HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
U.S. & CANADA 1-800-922-1919 • MEXICO 1-800-522-1900 • WWW.HUSSMANN.COM
3
P/N 0512888_A
01 October 2009
MAXI-140
Hussmann Beer Merchandiser
MAXI-140
Optional Leg Kit
To maintain NSF standards of cleanability
when sealing cannot be done, Hussmann offers
optional leg kits that raise the MAXI-140
four or six inches. Directions are included with
the optional leg kit (Aftermarket
P/N TP.4900288).
LEVEL
Hussmann Beer Merchandisers must be level
front-to-back and side-to-side to operate at
peak efficiency. Shimming may be necessary.
Ensure all sides are firmly supported. Use care
when shimming legs.
PLUG IN
Put the Hussmann Beer Merchandiser on its
own dedicated electrical circuit with ground.
12AWG is the minimum size wire acceptable.
• The MAXI-140
requires a dedicated 15 Amp
circuit with grounded wall
receptacle
(NEMA 5-15P)
• Do not use extension cords.
Never use adapters.
• If in doubt, call an electrician.
Electrical requirements for the merchandiser
are stated on the serial plate attached to the
unit.
If the power supply oscillates beyond the range
given in the preceding table, install a voltage
regulator.
Light Switch
The MAXI-140 merchandiser light switch is
located on the right rear of the interior top
panel. It controls the exterior canopy light;
LED lighting is
ON at all times.
MAXI-140MAXI-140MAXI-140MAXI-140
NEMA 5-15P
MAXI-140
MAXI-140
1000 VA
Nominal
Voltage
Minimum
Voltage
Maximum
Voltage
120 108 132
Light switch
IMPORTANT:
After leveling, wait at least 30 minutes
before turning on power to the Hussmann
Beer Merchandiser to allow any oil residue
to return to the compressor.
Oil not in the compressor at start up may
cause permanent damage not covered by
warranty.
INSTALL SHELVES
The MAXI-140 comes standard with
one fixed wire shelf (with or without dividers)
and one removable flat wire shelf.
The removable lower shelf must be placed flush
against the back to maintain proper air flow
and product temperature.
DOOR HINGES
The MAXI-140 door is not self-closing.
The top door hinge has slots that allow the
door to be adjusted if the gasket doesn’t seal
completely.
Use a nut driver to loosen the four hex-head
screws just enough to allow the hinge to move
backward which will tighten the door seal.
4
P/N 0512888_A
01 October 2009
MAXI-140
©2009 HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
U.S. & CANADA 1-800-922-1919 • MEXICO 1-800-522-1900 • WWW.HUSSMANN.COM
MAXI-140 Fixed Upper
Shelf with Dividers
Slots
Slots
Top of MAXI-140
Loosen Screws
Loosen Screws
Removable Lower Shelf
with Product Stop to Rear
Fixed Upper Shelf
Shown with Dividers
Shelf Fasteners
Removable Lower Shelf with Product Stop to Rear
MAXI-140 Fixed Upper
Shelf without Dividers
Loading...