Hussmann DSFM Specifications
5
Specialty Products
DSFM
These merchandisers are manufactured to meet ANSI/National Sanitation
Foundation Standard #7 requirements.
We reserve the right to change or revise specifications and
product design in connection with any feature of our
products. Such changes do not entitle the buyer to
corresponding changes, improvements, additions or
replacements for equipment previously sold or shipped.
40427
ETL Listed
DSFM
Technical Data Sheet
Rev C
REFRIGERATION DATA
Note: This data is based on store temperature and
humidity that does not exceed 75F and 55% R.H.
Discharge Air (F) 28
Evaporator (F) 20
Note: Not recommended to control temp by regulating
coil temp allow t-stat to cycle and control temp.
Btu/hr/ft*
Parallel 500
Conventional 575
*For all refrigeration equipment other than Hussmann,
use conventional Btu values.
DEFROST DATA
Frequency Hrs 8
OFFTIME
Temp Term °F 54
Failsafe Minutes 46
ELECTRIC or GAS Not Recommended
Merchandiser Drip Pipe (in.) 2
Merchandiser Liquid Line (in.) 3/8*
Merchandiser Suction Line (in.) 5/8*
Estimated Charge (lb)***
*Dependent on case length and refrigerant type.
*** This is an average for all refrigerants types. Actual
refrigerant charge may vary by approximately half a
pound.
GPM PSI
2ft 0.4 0.3
3ft 0.5 1.0
4ft 0.7 2.1
5ft 0.9 3.5
6ft 1.1 5.1
8ft 1.4 1.7
10ft 1.8 2.6
12ft 2.1 3.6
PHYSICAL DATA
4ft 1.2
5ft 1.5
6ft 1.8
GLYCOL REQUIREMENTS
ETL Sanitation
1 of 5
40427
5
Engineering
CROSS SECTION
Specialty Products
DSFM
DSFM
Technical Data Sheet
Rev C
2 of 5
Loading...