Husqvarna 966043502, 70 LP User Manual
MODEL
MODEL
MODELMODEL
70 LP
70 LP
70 LP70 LP
OWNER’S MANUAL
OWNER’S MANUAL
OWNER’S MANUALOWNER’S MANUAL
ASSEMBLY
ASSEMBLY
ASSEMBLYASSEMBLY
RH. Handle
Brace
1
. Remove components from carton
and place spreader upside down on a
padded surface. Install LH. & RH. handle
braces to frame as shown using four (4)
1/4-20 x 2 1/4” hex bolts and nuts but do
not tighten.
3/16 Dia x 2”
Cotter Pin
Drive Wheel
1/8 Dia x 1 1/4”
Cotter Pin
1/4-20 x 2 1/4”
Hex Bolt
1/4-20
Hex Nut
LH. Handle
Brace
2
. Slide wheels onto end of axle with
the hub facing toward frame. Wheels are
identical to ease assembly. Align the
hole in the wheel hub and the hole in the
axle as shown. Secure drive wheel to
axle with 3/16 dia. x 2” cotter pin. Insert
1/8 dia. x 1 1/4” cotter pin in the hole
near the end of axle to retain free
turning wheel.
Free Turning
Wheel
3
. Turn spreader upright. For ease of
assembly, make sure ON/OFF cable is on
top of handle braces. With DOT on the
handle assembly facing as shown, secure
clamp bracket using a #10 x 3/4 slotted
sheet metal screw. Install end of handle
assembly between handle braces and
secure with (2) 1/4-20 x 1 1/2” hex bolts
and nuts.
2
#10 x 3/4
Sheet Metal
Screw
Clamp
Bracket
ON/OFF Cable
DOT
Handle
Assembly
1/4-20
Hex Nut
1/4-20 x 1 1/2”
Hex Bolt
Handle Grip
ON/OFF Control
4
. Attach ON/OFF control to the upper
handle using (2) #10 x 3/4” slotted
sheet metal screws. Slide handle grips
onto the handle cross tube. Soapy
water will ease installation. (Do not use
petroleum based products).
#10 x 3/4”
Sheet Metal Screws
5.
Secure On/Off cable to the clamp
bracket using the cable clamp and
#10-24 x 5/8” screw and locknut as
shown but do not tighten. Place On/
Off control in the “ON” position and
set the rate retting dial to the
“WASH” position. Pull cable away
from hopper sliding it in the cable
clamp until the shut off plate stops
against the rate setting dial. Tighten
cable clamp securely. To check
spreader for complete shutoff, pull
the On/Off control lever back to the
“OFF” position. Check to make sure
hole in the hopper is completely
closed. If not, loosen the cable
clamp and slide the cable forward
until the hole in hopper is closed.
Re-tighten bolt and check shutoff
.
ON/OFF Cable
Clamp
#10-24 x 5/8”
Screw & Locknut
Shut Off
Plate
Clamp
Bracket
ON
Rate Setting
Dial
Screen
Screen Clips
3
6
. Insert screen into hopper by sliding
it under the screen clips.
Loading...