Husky Liners 9134 User Manual

CARPET LINER CARE AND USE INSTRUCTIONS

Your new 3D® carpet liners are custom molded to fit your vehicle. The liners are made to take the place of

your factory floor mats. For the correct fit, it is necessary to remove the factory floor mats before installing your

new carpet liners. However, do not remove the factory-installed carpeting.

Your liners are made from a unique combination of a lightweight thermoplastic foam and a high quality

automotive grade carpet that is extremely tough and durable. To clean your carpet liners, vacuum first to

remove loose debris and then use a damp sponge to spot clean. If you wish to use a commercial cleaner,

cleaners such as Resolve®, Woolite®, Capture® or similar products are suggested. Read and follow the care

and use instructions provided with these products. Spot removal is most effective when the soiled area is treated

promptly. Do not use solvent-based cleaners or cleaners containing bleach as these may discolor your carpet.

juxtaposed

Your 3D® carpet liners come with a lifetime warranty against tearing and cracking. For warranty

information or to see other products we have available for your vehicle, please see our web site,

http://www.huskyliners.com.

ALIGNMENT VIEW SHOWING PLACEMENT OF YOUR 1997-2003 FORD

F-150 AND 1997-1998 F-250 LT. DUTY REGULAR AND SUPER CAB TRUCKS

9134_Insert X 2.doc

02/19/03

CARPET LINER INSTALLATION INSTRUCTIONS

Velcro® Dot on back of liner.

Your new 3D® Carpet Liners are designed to be held firmly in place with a Velcro® anchoring system. You
will find that each of your front liners come with two Velcro® “hook” patches applied to the underneath surface
of the liners. In the hardware bag included in the shipping container you will find 4 anchor screws with the
“loop” portion of the Velcro® applied. The anchor screws will need to be installed in your factory carpet
directly beneath the Velcro® hook patches to hold the liners in place. The anchor screws will not damage your
carpet and can easily be removed if necessary.
To align the anchors with the patches on the liner, first place your liner in the vehicle, adjusting it to the
proper fit. Then, pull up a corner of your liner as shown in the photo below and attach the anchor screw to the
Velcro® pad on the liner. Lower the raised edge and note the position where the anchor screw touches the
vehicle carpet. There are many ways to mark this location; here are a couple of suggestions:

•Apply a 1” strip of masking tape directly to the carpet underneath the anchor screw. When the anchor screw
is lowered, it will pierce the tape and mark the location.

•Insert a straight pin (needle) next to the point where the anchor screw contacts the carpet to mark the screw
location.

Removal of the factory carpet hook is recommended. The carpet hook can be removed using a
screwdriver to release them. Use a flat wide blade screwdriver, sliding it under the front edge of the
clip. Carefully apply pressure and twist to release the clip (pushing from the firewall towards the seat).

Velcro® Dot on back of liner.

Anchor screw will pierce masking

tape, marking screw location.

Anchor screw shown attached to

With screw secured in carpet, align Velcro®

halves to secure liner in place.

9134_Insert X 2.doc

02/19/03