Page 1
CARPET LINER CARE AND USE INSTRUCTIONS
Your new Husky 3D® carpet cargo liner is custom molded to fit your vehicle. Upon removal from the box your liner
will not completely unroll and lay flat. This is normal and only temporary. Just place the liner on the floor or in the
back of your vehicle with a weight in each corner (a book works well). In a short time, your liner will remain flat. In
colder climates this “relaxing” may take longer; moving the liner to a heated area will accelerate the process.
Your liner is made from a unique combination of a lightweight thermoplastic foam and a high quality automotive
grade carpet that is extremely tough and durable. To clean your carpet liners, vacuum first to remove loose debris and
then use a damp sponge to spot clean. If you wish to use a commercial cleaner, cleaners such as Resolve®,
Woolite®, Capture®, or similar products are suggested. Read and follow the care and use instructions provided with
these products. Spot removal is most effective when the soiled area is treated promptly. Do not use solvent-based
cleaners or cleaners containing bleach as these may discolor your carpet.
Your 3D® cargo liner comes with a lifetime warranty. For detailed warranty information or to see other products
we have available for your vehicle, please see our web site, http://www.huskyliners.com.
INSTALLATION INSTRUCTIONS FOR YOUR 1997-2002 FORD EXPEDITION
AND 1998-2002 LINCOLN NAVIGATOR CARPET 3D CARGO LINER
TO USE YOUR CARGO LINER IN
VEHICLES EQUIPPED WITH THE
OPTIONAL THIRD SEAT, SIMPLY TRIM
THE MATERIAL AWAY FROM INSIDE
OF THE AREAS SHOWN TO THE RIGHT
CROSSHATCHED. TRIMMING CAN
EASILY BE DONE WITH A UTILITY
KNIFE OR HEAVY SHEARS. USE THE
COMPRESSED GROOVE SURROUNDING THE NOTED AREAS AS A
GUIDE FOR TRIMMING. ONCE
TRIMMED, REMOVE YOUR SEATS AND
REINSTALL THE ATOP THE LINER.
YOUR SEAT MOUNTING BRACKETS
WILL PASS THROUGH THE TRIMMED
AREAS IN THE CARGO LINER. CHECK
TO BE SURE THAT THE SEATS ARE
PROPERLY ATTACHED BEFORE
OPERATING VEHICLE. THE SMALL
HOLE WITH THE “1” INSIDE IT ALLOWS
THE SEAT BELT TO PASS THROUGH
THE LINER. TO “RELEASE” THE SEAT
BELT FROM THE FLOOR, PUSH YOUR
KEY OR SIMILAR OBJECT IN THE HOLE
LOCATED IN THE PLASTIC HOUSING.
PART NUMBER MOLDED ON BACK SIDE OF LINER
9102_Insert.doc
02/07/03
Loading...