Husky Liners 8905 User Manual

8905.doc
04/29/05

THANK YOU FOR SELECTING A HUSKY FLOOR LINER

FROM WINFIELD CONSUMER PRODUCTS

CARE AND USE INSTRUCTIONS

Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of your

factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your new floor

liner. However, do not remove the factory-installed carpeting.

Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The easiest way

to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well. Use of Armor

All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.

INSTALLATION INSTRUCTIONS FOR YOUR CHEVROLET

CORVETTE FRONT FLOOR LINERS

NOTICE: TO ALLOW FULL SEAT TRAVEL, CORVETTE OWNERS WHOSE VEHICLES ARE EQUIPPED WITH THE
SPORT SEAT OPTION WILL NEED TO TRIM THEIR HUSKY LINERS® AS SHOWN ABOVE. TO TRIM, REMOVE
THE OFFSET PORTION OF THE BACK WALL, CUTTING ALONG THE SLOPING RIDGE DEFINING THE OFFSET.
FINISH BY CUTTING ALONG THE INTERSECTION MADE BY THE BACK WALL AND THE RAISED BAND
BORDERING THE PART. REPEAT THIS PROCEDURE FOR THE OPPOSING LINER. A UTILITY KNIFE OR HEAVY
SCISSORS WORKS WELL FOR TRIMMING.

LEFT OR

DRIVER’S

SIDE

RIGHT OR

PASSENGER’S

SIDE