Page 1
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of your
factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your new floor
liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The easiest
way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well. Use of
Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR FORD
CENTER HUMP LINER
TRIM THIS STRIP OFF ON 1999
AND NEWER VEHICLES. TRIM
ALONG THE RAISED RIDGE.
NOTE: IF YOUR VEHICLE HAS A MANUAL SHIFT TRANSFER CASE AND IS A 1999 OR 2000 MODEL REMOVE THE
TREAD PLATE FROM AREA “1” SHOWN ABOVE. IF IT IS A 1997 OR 1998 MODEL, TRIM OUT ALL THE MATERIAL
INSIDE THE _ INCH BAND. IF YOUR VEHICLE HAS A CENTER CONSOLE, TRIM THE MATERIAL AWAY FROM AREA “2”
SHOWN ABOVE. A UTILITY KNIFE OR HEAVY SCISSORS WORK WELL FOR TRIMMING
8236.DOC
Rev: 0
02/01/01
Loading...