Page 1
7377-1.doc
01/11/2006
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of your
factory floor mats. For correct fit, it is necessary to remove the factory floor mat(s) before installing your new
floor liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The easiest
way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well. Use of
Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR THIRD SEAT
FORD EXPLORER/MERCURY MOUNTAINEER FLOOR LINER
(WITH 2ND ROW BENCH SEATS)
FRONT OF VEHICLE
TO INSTALL YOUR LINER, SIMPLY RELEASE AND FLIP/FOLD FORWARD BOTH OF YOUR SECOND ROW
BENCH SEATS. THEN, LOCATE THE TWO CHILD SAFETY HOOKS LOCATED ALONG THE BACK WALL
OF THE 3RD SEAT’S MOUNTING PLATFORM AND MAKE SURE THEY ARE FIRMLY TUCKED AGAINST
THE MOUNTING PLATFORM. WITH THESE STEPS COMPLETED, YOU CAN EASILY POSITION YOUR
LINER INTO PLACE.
NOTE THAT THE SECOND ROW SEATS WILL REATTACH THROUGH THE THREE (3) PRE-TRIMMED
HOLES IN THE LINER. IF THE THREE (3) AREAS DARKENED/NUMBERED ABOVE ARE NOT TRIMMED
OUT WHEN YOU RECEIVE YOUR LINER, DO NOT INSTALL YOUR LINER. INSTEAD, PLEASE CALL US AT
800-344-8759
TO ACCESS THE CHILD SAFETY SEAT HOOKS WITH YOUR LINER IN PLACE, SIMPLY TRIM THE
MATERIAL AWAY FROM THE TWO (2) LOWERED AREAS LOCATED ALONG THE BACK WALL OF THE
LINERS (SHOWN CIRCLED ABOVE—SEE PHOTO ON BACK OF THIS PAGE).
1
3
2
Page 2
7377-1.doc
01/11/2006
Loading...