Page 1
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place
of your factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing
your new floor liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The
easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus
work well. Use of Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the
liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR THIRD SEAT
FORD EXPLORER/MERCURY MOUNTAINEER FLOOR LINER
FRONT OF VEHICLE
®
TO INSTALL YOUR LINER, FIRST UNLATCH BOTH SECOND SEATS ALLOWING THEM TO “FLIP”
FORWARD. THIS IS NECESSARY AS THE LINER COVERS THE “STEP IN” AREA LOCATED
UNDERNEATH THE SECOND SEATS. YOUR LINER SHOULD HAVE THE AREAS SHOWN CIRCLED
ABOVE TRIMMED TO ALLOW THE SECOND SEATS TO LATCH PROPERLY. IF THIS AREA IS NOT
TRIMMED, DO NOT INSTALL THE LINER. INSTEAD, USE A UTILITY KNIFE OR HEAVY SHEARS TO
TRIM THE MATERIAL IN THIS AREA AWAY FOLLOWING THE MOLDED GROOVE. THE LINER CAN
THEN BE SAFELY INSTALLED.
7375.DOC
Rev: 0
04/10/01
Loading...