Page 1
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
BEFORE INSTALLATION OF YOUR NEW HUSKY LINER YOU MUST FIRST RELEASE AND FLIP YOUR
SECOND SEATS FORWARD. ALWAYS MAKE CERTAIN THAT THE SEATS ARE SECURELY LOCKED INTO
POSITION BEFORE DRIVING VEHICLE.
NAVIGATOR OWNERS: TO ALLOW CORRECT FIT IN VEHICLES WITH THE SECOND ROW CONSOLE, IT
WILL BE NECESSARY TO TRIM YOUR LINER AS SHOWN ABOVE. TRIM LINER BY CUTTING ALONG THE
CENTER OF THE RAISED WALL USING THE MOLDED IN GROOVE AS A GUIDE. A UTILITY KNIFE OR
HEAVY SHEARS WORK WELL FOR TRIMMING. *TRIMMING PHOTOS SHOWN ON THE BACK OF THIS PAGE.
VEHICLES WITH SECOND ROW BENCH SEATS USE HUSKY LINER PART #7355.
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of your
factory floor mats. For correct fit, it is necessary to remove the factory floor mat(s) before installing your new
floor liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The easiest
way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well. Use of
Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR THIRD SEAT FORD
EXPEDITION /LINCOLN NAVIGATOR FLOOR LINER
THIS PART FITS VEHICLES WITH SECOND ROW BUCKET SEATS ONLY, FOR
AREAS SHOWN CROSSHATCHED ABOVE SHOULD BE
TRIMMED WHEN YOU RECEIVE YOUR LINER. THE HOLES
ALLOW THE SECOND SEAT TO LOCK INTO PLACE. DO
NOT INSTALL LINER WITHOUT AREAS TRIMMED.
7356.doc
08/28/02
Loading...