Page 1
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liners are custom molded to fit your particular vehicle. The liners are made to take the place of
your factory floor mats. For correct fit, it is necessary to remove the factory floor mats before installing your new
floor lines. However, do not remove the factory-installed carpeting.
Your liners are made from an engineering resin that is lightweight and extremely tough and durable. The easiest
way to clean your liners is with a damp cloth or sponge. If using a cleaner, 409
®
or Glass Plus® work well. Use of
Armor All
®
, Son-of-a-Gun® or similar items is discouraged as these products make the liners slick.
INSTALLATION INSTRUCTIONS FOR YOUR MERCEDES ML-
320/430 SECOND SEAT FLOOR LINERS
ON SOME 1999 AND 2000 MODEL MERCEDES VEHICLES IT MAY BE NECESSARY TO TRIM YOUR LINERS TO
INSURE PROPER FIT. THIS CAN BE EASILY ACCOMPLISHED USING A UTILITY KNIFE OR HEAVY SCISSORS.
FIRST, TEST FIT THE LINERS IN YOUR VEHICLE. YOU MAY NOTICE THAT THE DRIVER’S SIDE LINER IS TO
LONG. IF THIS IS THE CASE, YOU WILL TO NEED TO REMOVE THE PORTION OF THE DRIVER’S SIDE MAT AS
SHOWN ABOVE (AREA 1). TRIM ACROSS THE LINER FOLLOWING THE GROOVE PROVIDED REMOVING THE
REAR PORTION OF THE LINER. IF THE CENTER CONSOLE INTERFERES WITH THE PASSENGER SIDE LINER,
TRIM AWAY THE RECESSED AREA OF THE LINER AS SHOWN ABOVE IN AREA 2. (SEE ATTACHED PHOTO’S
ON BACK)
Page 2
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD
DRIVER’S SIDE LINER SHOWN TRIMMED
SIDE LINER SHOWN TRIMMED
Loading...