Husky Liners 6620 User Manual

THANK YOU FOR SELECTING A HUSKY FLOOR LINER

FROM WINFIELD CONSUMER PRODUCTS

CARE AND USE INSTRUCTIONS

Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place
of your factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing
your new floor liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The

easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus
work well. Use of Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the

liner slick.

INSTALLATION INSTRUCTIONS FOR YOUR NISSAN

FRONTIER TRUCK SECOND SEAT FLOOR LINER

FRONT OF VEHICLE

®

DUE TO DIFFERENCES IN SIZING OF FACTORY EQUIPPED CONSOLES, YOUR FRONTIER
EXTENDED CAB TRUCK LINER MAY NEED MINOR TRIMMING TO CORRECTLY FIT YOUR
TRUCK. FIRST, TEST FIT YOUR LINER. IF YOU FIND INTERFERENCE WITH THE CONSOLE,
PLEASE TRIM YOUR LINER AS SHOWN ABOVE. IF NECESSARY, THE TRIMMING IS EASILY
DONE USING THE RECESSED GROOVE AS A TRIM GUIDE. TRIMMING PHOTOS ARE
INCLUDED ON THE BACK OF THIS PAGE.

6620 Front_Back.doc

Rev: 1

01/18/02

TRIMMING PHOTOS OF PART #6620

FRONTIERS TRUCKS WITH SHORTER CONSOLE.

PART #6620 SHOWN UNTRIMMED FOR USE IN

PART #6620 SHOWN TRIMMED FOR FRONTIERS

TRUCKS WITH LONGER CONSOLE. TRIM USING

MOLDED IN GROOVE AS A GUIDE.

6620 Front_Back.doc

Rev: 1

01/18/02