Husky Liners 6510FR User Manual

THANK YOU FOR SELECTING A HUSKY FLOOR LINER

FROM WINFIELD CONSUMER PRODUCTS

CARE AND USE INSTRUCTIONS

Your new floor liner is custom molded to fit your particular vehicle. The liners are made to take the place of your
factory floor mats. For correct fit it is necessary to remove the factory floor mats before installing your new floor
liners. However, do not remove the factory installed carpeting.
Your liners are made from an engineering resin that is lightweight and extremely tough and durable. The easiest

way to clean your liners is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well. Use of
Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liners slick.

INSTALLATION INSTRUCTIONS FOR YOUR TOYOTA TACOMA

SECOND SEAT LINER

FRONT OF VEHICLE

LEFT OR

DRIVER’S SIDE

NOTICE: RIGHT LINER

NOTICE: LEFT LINER

OVERLAPS LEFT LINER

OVERLAPS RIGHT LINER

TACOMA’S EQUIPPED WITH A CENTER CONSOLE WILL NEED TO HAVE THEIR HUSKY LINERS TRIMMED TO
ALLOW PROPER FIT. TRIM LINER FOLLOWING THE SCRIBED LINES ON THE PASSENGER SIDE LINER’S HUMP
PORTION, PASSING APPROXIMATELY _” ABOVE THE RAISED BAND BISECTING THE TREADED AREA ON THE
HUMP (SEE ABOVE). A UTILITY KNIFE OR HEAVY SHEARS WORK WELL FOR TRIMMING. A PHOTO ON THE
BACK SHOWS A TRIMMED PART.

RIGHT OR

PASSENGER’S SIDE

6510FR~1.DOC

Rev: 1

02/01/01

PART NUMBER 6510 TOYOTA TACOMA SHOWN TRIMMED FOR

FACTORY CENTER CONSOLE

6510FR~1.DOC

Rev: 1

02/01/01