Husky Liners 6387 User Manual
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the
place of your factory floor mats. For correct fit, it is necessary to remove the factory floor mat before
installing your new floor liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable.
The easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass
Plus® work well. Use of Armor All®, Son-of-a-Gun® or similar items is discouraged as these products
make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR SUPER
DUTY FORD TRUCK SECOND SEAT FLOOR LINER
FRONT OF VEHICLE
LOCATING BOSS
ON 2003_ AND NEWER MODEL YEAR FORD SUPER DUTY TRUCKS; FORD HAS
REPOSITIONED THE JACK TOOL POUCH TO A LOCATION UNDER THE REAR SEAT. YOUR
HUSKY LINER IS DESIGNED TO ACCOMMODATE THE RELOCATED TOOL POUCH.
INSTALLATION OF YOUR HUSKY LINER IS EASILY DONE BY FOLLOWING THESE SIMPLE
STEPS: FIRST, TRIM AWAY THE MATERIAL FROM THE TOP OF THE RAISED LOCATING
BOSS MOLDED INTO THE LINER (SEE DRAWING ABOVE). SECOND, REMOVE THE JACK
TOOL POUCH AND SECURING BRACKETS. THIRD, INSTALL YOUR LINER AND REPLACE
THE TOOL POUCH ASSEMBLY SECURING IN PLACE WITH THE ORIGINAL BRACKETS
AND WING NUT STUD. TO AID IN INSTALLATION, FIRST FOLD UP REAR SEAT BOTTOMS.
INSTALLATION PHOTOS ARE INCLUDED ON THE BACK OF THIS SHEET.
6387 Front_Back.doc
09/17/03
HUSKY LINER PART #6387 INSTALLATION PHOTOS
SHOWN IS THE JACK TOOL POUCH WHICH WAS REPOSITION
MID-YEAR (2003_) TO UNDER THE REAR SEAT.
BOSS LOCATED IN LINER
(SHOWN TRIMMED)
TO RELOCATE TOOL POUCH ATOP LINER: REMOVE POUCH,
TRIM HOLE IN RAISED BOSS ON LINER (REMOVE RECESSED
AREA), AND REINSTALL POUCH (ALIGNING SO THAT FACTORY
FASTENER ATTACHES THROUGH TRIMMED HOLE.
PHOTO OF LINER WITH JACK TOOLS INSTALLED.
6387 Front_Back.doc
09/17/03
Loading...