THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the
place of your factory floor mats. For correct fit, it is necessary to remove the factory floor mat before
installing your new floor liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable.
The easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass
Plus® work well. Use of Armor All®, Son-of-a-Gun® or similar items is discouraged as these products
make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR SUPER
DUTY FORD TRUCK SECOND SEAT FLOOR LINER
FRONT OF VEHICLE
LOCATING BOSS
ON 2003_ MODEL YEAR FORD SUPER DUTY TRUCKS; FORD HAS REPOSITIONED THE
JACK TOOL POUCH TO A LOCATION UNDER THE REAR SEAT. YOUR HUSKY LINER IS
DESIGNED TO ACCOMMODATE THE RELOCATED TOOL POUCH. INSTALLATION OF THE
LINER IS EASILY DONE BY FOLLOWING THESE SIMPLE STEPS: FIRST, TRIM AWAY THE
MATERIAL FROM THE TOP OF THE RAISED LOCATING BOSS MOLDED INTO THE LINER
(SEE DRAWING ABOVE). SECOND, REMOVE THE JACK TOOL POUCH AND SECURING
BRACKETS. THIRD, INSTALL YOUR LINER AND REPLACE THE TOOL POUCH ASSEMBLY
SECURING IN PLACE WITH THE ORIGINAL BRACKETS AND WING NUT STUD. TO AID IN
INSTALLATION, FIRST FOLD UP REAR SEAT BOTTOMS. PHOTOS ARE INCLUDED ON THE
BACK OF THIS SHEET.
6386
07/08/03
HUSKY LINER PART #6386 INSTALLATION PHOTO
SHOWN IS THE JACK TOOL POUCH WHICH WAS REPOSITION
MID-YEAR (2003_) TO UNDER THE REAR SEAT.
BOSS LOCATED IN LINER
(SHOWN TRIMMED)
TO RELOCATE TOOL POUCH ATOP LINER: REMOVE POUCH,
TRIM OUT HOLE IN RAISED BOSS ON LINER, AND
REINSTALL POUCH (ALIGNING SO THAT FACTORY
FASTENER ATTACHES THROUGH TRIMMED HOLE.
PHOTO OF LINER WITH JACK TOOLS INSTALLED.
6386
07/08/03
Loading...