Husky Liners 6368 User Manual

6368 Front_Back.doc

01/22/2004

THANK YOU FOR SELECTING A HUSKY FLOOR LINER

FROM WINFIELD CONSUMER PRODUCTS

CARE AND USE INSTRUCTIONS

Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of your

factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your new floor

liner. However, do not remove the factory-installed carpeting.

Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The easiest way

to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well. Use of Armor

All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.

INSTALLATION INSTRUCTIONS FOR YOUR FORD F-150

SUPER CREW TRUCK SECOND SEAT FLOOR LINER

ON VEHICLES EQUIPPED WITHOUT A FACTORY CENTER CONSOLE, IT WILL BE NECESSARY TO TRIM AWAY
A PORTION OF THE LINER. TRIM BY REMOVING THE RECESSED AREA OF THE LINER ALONG THE FRONT
EDGE AS SHOWN ABOVE (SEE AREA 1). A UTILITY KNIFE OR SCISSORS WORK WELL FOR TRIMMING. USE
OFFSET “STEP” AS TRIMMING GUIDE. SEE BACK OF PAGE FOR TRIMMING PHOTOS.

ON VEHICLES EQUIPPED WITH A FACTORY SUBWOOFER (UNDER DRIVER’S SIDE REAR SEAT), TRIM LINER
AS SHOWN ABOVE (AREA 2). USE THE RAISED GROOVE AS A TRIM GUIDE, TRIMMING ALONG THE BACK
EDGE (LEAVING RAISED AREA). CONTINUE TRIM OVER HUMP FOLLOWING OFFSET STEP IN PART AS A
GUIDE. TRIMMING PHOTOS ARE INCLUDED ON BACK OF THIS PAGE.

RIGHT OR

PASSENGER’S

SIDE

LEFT OR

DRIVER’S

SIDE

AREA 1

AREA 2

6368 Front_Back.doc

01/22/2004

6368 PART UNTRIMMED. USE UNTRIMMED
PART IN VEHICLE WITH FACTORY CENTER
CONSOLE BETWEEN FRONT SEATS.

6368 PART SHOWN TRIMMED. USE TRIMMED
PART IN VEHICLE WITHOUT FACTORY
CENTER CONSOLE BETWEEN FRONT SEATS.

PART #6368 SHOWN TRIMMED FOR USE WITH FACTORY SUBWOOFER (LARGE PHOTO) AND

ALSO SHOWN IN VEHICLE WITH FACTORY CONSOLE AND REAR SEAT SUBWOOFER (INSET).

IT IS POSSIBLE TO INSTALL YOU HUSKY LINER SO THAT IT WILL TUCK UNDER
THE SUBWOOFER BOX. YOU WILL NEED TO REMOVE TWO OF THE ATTACHMENT
BOLTS AND LOOSEN THE THIRD WHICH WILL ALLOW THE SUBWOOFER BOX TO
BE RAISED ENOUGH TO SLIDE YOUR LINER UNDERNEATH IT.