Husky Liners 6367 User Manual

6367 Front_Back.doc

10/30/03

THANK YOU FOR SELECTING A HUSKY FLOOR LINER

FROM WINFIELD CONSUMER PRODUCTS

CARE AND USE INSTRUCTIONS

Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of your

factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your new floor

liner. However, do not remove the factory-installed carpeting.

Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The easiest way

to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well. Use of Armor

All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.

INSTALLATION INSTRUCTIONS FOR YOUR FORD F-150 SUPER CAB

TRUCK SECOND SEAT FLOOR LINER

ON VEHICLES EQUIPPED WITHOUT A FACTORY CENTER CONSOLE, IT WILL BE NECESSARY TO TRIM AWAY
A PORTION OF THE LINER. TRIM BY REMOVING THE RECESSED AREA OF THE LINER ALONG THE FRONT
EDGE AS SHOWN ABOVE (SEE AREA 1). A UTILITY KNIFE OR SCISSORS WORK WELL FOR TRIMMING. USE
OFFSET “STEP” AS TRIMMING GUIDE. SEE BACK OF PAGE FOR TRIMMING PHOTOS.

ON VEHICLES EQUIPPED WITH A FACTORY SUBWOOFER (UNDER DRIVER’S SIDE REAR SEAT), TRIM LINER
AS SHOWN ABOVE (AREA 2). USE THE RAISED GROOVE AS A TRIM GUIDE, TRIMMING ALONG THE BACK
EDGE (LEAVING RAISED AREA). CONTINUE TRIM OVER HUMP FOLLOWING OFFSET STEP IN PART AS A
GUIDE. TRIMMING PHOTOS ARE INCLUDED ON BACK OF THIS PAGE.

RIGHT OR

PASSENGER’S

SIDE

LEFT OR

DRIVER’S

SIDE

AREA 1

AREA 2

NOTICE: DURING THE 2004 MODEL YEAR, FORD WILL PRODUCE TWO VERSIONS OF THE F-150 TRUCK.
THIS LINER IS DESIGNED SPECIFICALLY FOR ALL NEW F-150. THE OTHER 2004 FORD F-150 AVAILABLE
IS THE “HERITAGE EDITION” WHICH IS A CONTINUATION OF THE PREVIOUS OR “OLD BODY” STYLE. IF
YOU HAVE A 2004 HERITAGE EDITION TRUCK, YOU NEED HUSKY SECOND SEAT LINER PART #6334.

6367 Front_Back.doc

10/30/03

6367 PART UNTRIMMED. USE UNTRIMMED
PART IN VEHICLE WITH FACTORY CENTER
CONSOLE BETWEEN FRONT SEATS.

6367 PART SHOWN TRIMMED. USE TRIMMED
PART IN VEHICLE WITHOUT FACTORY
CENTER CONSOLE BETWEEN FRONT SEATS.

PART #6367 SHOWN TRIMMED FOR USE WITH FACTORY SUBWOOFER (LARGE PHOTO) AND

ALSO SHOWN IN VEHICLE WITH FACTORY CONSOLE AND REAR SEAT SUBWOOFER (INSET).

YOU CAN ALSO INSTALL YOUR HUSKY LINER UNDERNEATH OF THE SUBWOOFER BY

LOOSENING THE SUBWOOFER ATTACHMENT BOLTS AND SLIDING THE LINER UNDER IT.

PART 6367 SHOWN UNTRIMMED IN A 2004

F150 WITH FRONT SEAT CONSOLE.

PART 6367 SHOWN TRIMMED IN A 2004

F150 WITH FRONT SEAT CONSOLE