Page 1
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of your
factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your new floor
liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The easiest
way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well. Use of
Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR FORD F-150
SUPER CREW TRUCK SECOND SEAT FLOOR LINER
AREA 1
LEFT OR
DRIVER’S
SIDE
AREA 2
ON VEHICLES EQUIPPED WITHOUT A FACTORY CENTER CONSOLE, IT WILL BE NECESSARY TO TRIM
AWAY A PORTION OF THE LINER. TRIM BY REMOVING THE RECESSED AREA OF THE LINER ALONG THE
FRONT EDGE AS SHOWN ABOVE (SEE AREA 1). A UTILITY KNIFE OR SCISSORS WORK WELL FOR
TRIMMING. USE OFFSET “STEP” AS TRIMMING GUIDE. SEE BACK OF PAGE FOR TRIMMING PHOTOS.
ON VEHICLES EQUIPPED WITH A FACTORY SUBWOOFER (UNDER DRIVER’S SIDE REAR SEAT), TRIM
LINER AS SHOWN ABOVE (AREA 2). USE THE RAISED GROOVE AS A TRIM GUIDE, TRIMMING ALONG THE
BACK EDGE (LEAVING RAISED AREA). CONTINUE TRIM OVER HUMP FOLLOWING OFFSET STEP IN PART
AS A GUIDE. TRIMMING PHOTOS ARE INCLUDED ON BACK OF THIS PAGE.
RIGHT OR
PASSENGER’S
SIDE
6366 Front_Back.doc
10/30/03
Page 2
6366 PART UNTRIMMED. USE UNTRIMMED
CONSOLE BETWEEN FRONT SEATS.
CENTER CONSOLE BETWEEN FRONT SEATS.
PART IN VEHICLE WITH FACTORY CENTER
6366 PART SHOWN TRIMMED. USE TRIMMED
PART IN VEHICLE WITHOUT FACTORY
PART #6366 SHOWN TRIMMED FOR USE WITH FACTORY SUBWOOFER (LARGE PHOTO) AND
ALSO SHOWN IN VEHICLE WITH FACTORY CONSOLE AND REAR SEAT SUBWOOFER (INSET).
6366 Front_Back.doc
10/30/03
Loading...