Husky Liners 6317 User Manual

6317 Front_Back.doc

06/14/04

THANK YOU FOR SELECTING A HUSKY FLOOR LINER

FROM WINFIELD CONSUMER PRODUCTS

CARE AND USE INSTRUCTIONS

Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of

your factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your

new floor liner. However, do not remove the factory-installed carpeting.

Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The

easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work

well. Use of Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner

slick.

INSTALLATION INSTRUCTIONS FOR YOUR FORD

ESCAPE/MAZDA TRIBUTE SECOND SEAT FLOOR LINER

FORD ESCAPE’S AND MAZDA TRIBUTE’S COME EQUIPPED WITH TWO STYLES OF CENTER
CONSOLES (SEE PHOTOS ON BACK). YOUR HUSKY LINER WILL ACCOMMODATE BOTH
CONSOLE STYLES BUT SOME TRIMMING MAY BE REQUIRED. TEST FIT YOUR LINER TO
DETERMINE IF YOUR LINER NEEDS TRIMMED. IF TRIMMING IS NECESSARY, IT IS EASILY
DONE BY TRIMMING ALONG THE INSIDE THE RAISED BAND ON OF THE LINER (SEE ABOVE).
ADDITIONAL TRIM AREAS ARE PROVIDED TO ACCOMMODATE THE POWER SEAT TRACK
MOVEMENT ON THE OPTIONAL DRIVER’S SIDE POWER SEAT (SEE #1 AND #2 ABOVE). TRIM
THE RECESSED PORTION OF THE WALL AWAY USING A UTILITY KNIFE OR HEAVY SHEARS.
ADDITIONAL PHOTOS ARE INCLUDED ON THE BACK OF THIS INSTRUCTION SHEET TO AID IN
TRIMMING.

FRONT OF VEHICLE

1

2

6317 Front_Back.doc

06/14/04

PHOTOS OF HUSKY LINER #6317 SHOWING CONSOLE STYLES AND TRIMMING

(WHERE APPLICABLE)

6317 SHOWN TRIMMED FOR USE WITH

POWER SEAT EQUIPPED MODELS

6317 SHOWN IN VEHICLE WITH THE

LONG CONSOLE (UP TO 04’)

6317 SHOWN IN VEHICLE WITH THE

SHORT CONSOLE (UP TO 04’)

6317 SHOWN TRIMMED FOR USE

WITH LONG CONSOLE (UP TO 04’)