Page 1
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FRONT OF VEHICLE
SIDE
SIDE
OVERLAPS LEFT LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liners are custom molded to fit your particular vehicle. The liners are made to take the place of
your factory floor mats. For correct fit, it is necessary to remove the factory floor mats before installing your new
floor liners. However, do not remove the factory-installed carpeting.
Your liners are made from an engineering resin that is lightweight and extremely tough and durable. The easiest
way to clean your liners is with a damp cloth or sponge. If using a cleaner, 409
Armor All
®
, Son-of-a-Gun® or similar items is discouraged as these products make the liners slick.
INSTALLATION INSTRUCTIONS FOR YOUR SECOND SEAT
CHEVROLET SUBURBAN/GMC YUKON XL FLOOR LINERS
LEFT OR
DRIVER’S
PASSENGER’S
®
or Glass Plus® work well. Use of
RIGHT OR
YUKON DENALI XL OWNERS WILL NEED TO TRIM THEIR DRIVER’S SIDE LINER AS SHOWN ABOVE TOP
TO ALLOW FOR THE LARGER CENTER CONSOLE (SEE PHOTOS ON BACK). TRIM AWAY THE LOWERED
AREA ON THE LINER. A UTILITY KNIFE OR HEAVY SHEARS WORK WELL FOR TRIMMING. ON VEHICLES
EQUIPPED WITH A REAR BENCH SEAT, A PORTION OF THE SECOND SEAT LINER (SHOWN ABOVE
HATCHED) CAN BE TRIMMED OFF TO ALLOW EASIER INSTALLATION AND REMOVAL. TRIM ALONG THE
EDGE OF THE BAND BISECTING THE CENTER PORTION
NOTICE: RIGHT LINER
6275FR~1.DOC
Rev: 0
11/27/00
Page 2
PHOTOS OF PART #6275 TRIMMED FOR THE YUKON XL
DENALI CENTER CONSOLE
v
6275FR~1.DOC
Rev: 0
11/27/00
Loading...