Husky Liners 6251 User Manual
6251 Front_Back.doc
12/22/2003
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of
your factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your new
floor liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The
easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work
well. Use of Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR CHEVROLET
COLORADO/GMC CANYON CREW CAB TRUCK SECOND SEAT LINER
YOUR COLORADO/CANYON LINER IS DESIGNED TO ACCOMMODATE TRUCKS WITH OR WITHOUT A
CENTER CONSOLE. IF YOU HAVE A FACTORY CENTER CONSOLE LOCATED BETWEEN THE FRONT
SEATS, IT WILL BE NECESSARY TO TRIM A SMALL PORTION OFF OF YOUR LINER TO ALLOW FOR THE
CORRECT FIT. TRIM YOUR LINER AS SHOWN PICTURED ABOVE. AN OFFSETTING DEPTH LINE IS
MOLDED INTO THE LINER TO SERVE AS A TRIMMING GUIDE. TRIM ALONG THE OFFSET AND AGAINST
THE RAISED BAND. A PHOTO OF A TRIMMED PART IS SHOWN ON THE BACK OF THIS PAGE. A UTILITY
KNIFE OR HEAVY SHEARS WORK WELL FOR TRIMMING.
FRONT OF VEHICLE
6251 Front_Back.doc
12/22/2003
PART #6251 COLORADO/CANYON LINER SHOWN TRIMMED
FOR VEHICLES WITH A CENTER CONSOLE
Loading...