6250 Front_Back.doc
12/22/2003
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of your
factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your new floor
liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The easiest
way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well. Use of
Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR CHEVROLET COLORADO &
GMC CANYON EXTENDED CAB TRUCK SECOND SEAT FLOOR LINER
YOUR COLORADO/CANYON LINER IS DESIGNED TO ACCOMMODATE TRUCKS WITH OR WITHOUT A
CENTER CONSOLE. IF YOU HAVE A FACTORY CENTER CONSOLE LOCATED BETWEEN THE FRONT SEATS,
IT WILL BE NECESSARY TO TRIM A SMALL PORTION OFF OF YOUR LINER TO ACHIEVE THE CORRECT FIT.
TRIM YOUR LINER AS SHOWN PICTURED ABOVE (AREA 1). AN OFFSETTING DEPTH LINE IS MOLDED INTO
THE LINER TO SERVE AS A TRIMMING GUIDE. TRIM ALONG THE OFFSET AND AGAINST THE RAISED
BAND. A PHOTO OF A TRIMMED PART IS SHOWN ON THE BACK OF THIS PAGE. A UTILITY KNIFE OR
HEAVY SHEARS WORK WELL FOR TRIMMING. THE TONGUE THAT EXTENDS BACKWARDS IN TO THE
AREA BETWEEN THE SECOND ROW SEATS CAN BE TRIMMED OFF AS WELL IF DESIRED (AREA 2 ABOVE).
TO REMOVE THIS AREA, USE THE MOLDED IN OFFSET LINE AS A TRIM GUIDE.
6250 Front_Back.doc
12/22/2003
PART #6250 COLORADO/CANYON LINER SHOWN TRIMMED
FOR VEHICLES WITH A CENTER CONSOLE
LINER SHOWN TRIMMED FOR VEHICLES WITH A CENTER CONSOLE
LINER SHOWN WITH REAR TONGUE TRIMMED. WE ARE NOT AWARE OF AN APPLICATION
THAT REQUIRES THAT THIS TONGUE BE TRIMMED, BUT THE AREA IT COVERS COULD BE
USED FOR VARIOUS STEREO COMPONENT INSTALLATIONS SO A TRIMMED WAS INCLUDED.