Page 1
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of your
factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your new floor
liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The easiest
way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well. Use of
Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR BLAZER
BRAVADA/JIMMY/ENVOY SECOND SEAT FLOOR LINERS
DO TO DIFFERENCES IN SEAT STYLES IN VARIOUS VEHICLES, FIRST INSTALL YOUR LINERS AS SHOWN
ABOVE, MOVING THE SEATS THROUGH THEIR ENTIRE RANGE OF MOTION. IF THE LINER(S) INTERFERE
WITH SEAT TRAVEL, IT MAY BE NECESSARY TO TRIM YOUR LINERS AS SHOWN ABOVE. REMOVE THE
MATERIAL FROM THE TOP OF THE RAISED AREAS LEAVING A _ INCH LIP. A UTILITY KNIFE OR SCISSORS
WORK WELL FOR TRIMMING.
FRONT OF VEHICLE
LEFT OR
DRIVER’S
SIDE
RIGHT OR
PASSENGER’S
SIDE
NOTICE: RIGHT LINER
OVERLAPS LEFT LINER
6230FR~1.DOC
Rev: 0
02/01/01
Page 2
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
#6230 DRIVER/PASSENGER LINERS SHOWN TRIMMED
PASSENGER’S SIDE LINER SHOWN
DRIVER’S SIDE LINER SHOWN TRIMMED
6230FR~1.DOC
Rev: 0
02/01/01
Loading...