THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FRONT OF VEHICLE
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of your
factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your new floor
liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The easiest
way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well. Use of
Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR DODGE
DURANGO SECOND SEAT FLOOR LINER
RIGHT OR
DRIVER’S SIDE
NOTE: LEFT LINER
OVERLAPS RIGHT LINER
*1998-2000 DURANGO OWNERS WILL NEED TO TRIM THEIR LINER AS SHOWN ABOVE TO ACCOMMODATE
THE SECOND SEAT CUP HOLDER THIS EASILY DONE USING A UTILITY KNIFE OR SCISSORS. PLEASE SEE
DIGITAL PHOTOS ON THE BACK OF THIS PAGE FOR TRIMMING REFERENCE.
LEFT OR
PASSENGER’S SIDE
6178FR~1.DOC
Rev: 0
02/01/01
DIGITAL IMAGES OF HUSKY LINER PART #6178 TRIMMED FOR USE IN
1998-2000 DURANGO’S
PART #6178 TRIMMED FOR A 1998-2000 DURANGO WITH FACTORY
BUCKET SEATS AND CONSOLE WITH AN ATTACHED CUP HOLDER.
USE THE EDGE OF THE TREADED AREA AS A TRIM GUIDE.
PART #6178 TRIMMED FOR A 1998-2000 DURANGO WITH A
FACTORY BENCH SEAT AND A SECOND SEAT CUP HOLDER. USE
THE MOLDED IN GROOVE AS A TRIM GUIDE.
6178FR~1.DOC
Rev: 0
02/01/01
Loading...