Page 1
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liners are custom molded to fit your particular vehicle. The liners are made to take the place of
your factory floor mats. For correct fit, it is necessary to remove the factory floor mats before installing your new
floor liners. However, do not remove the factory-installed carpeting.
Your liners are made from an engineering resin that is lightweight and extremely tough and durable. The
easiest way to clean your liners is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well.
Use of Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liners slick.
INSTALLATION INSTRUCTIONS FOR YOUR JEEP WRANGLER
SECOND SEAT FLOOR LINER
FRONT OF VEHICLE
LEFT OR
DRIVER’S SIDE
RIGHT OR
PASSENGER’S SIDE
NOTICE: LEFT LINER
OVERLAPS RIGHT LINER
SOME 2000 MODEL YEAR WRANGLER’S HAVE A FULL
CENTER CONSOLE THAT WILL INTERFERE WITH THE
PORTION OF THE LINER DESIGNED TO COVER THE
VEHICLE’S “HUMP” AREA. THIS PORTION CAN BE EASILY
TRIMMED AWAY USING A UTILITY KNIFE OR HEAVY
SHEARS. TRIM ALONG THE STEP MOLDED INTO THE
PASSENGER SIDE “HUMP” WALL LEAVING THE TOP OF THE
STEP AS A “LIP.” SEE DIAGRAM AT RIGHT. PHOTOS OF A
TRIMMED PART ARE ON SHOWN ON THE BACK OF THIS
INSTRUCTION SHEET.
6173FR~1.DOC
Rev: 0
09/20/00
Page 2
PHOTOS OF PART #6173 TRIMMED FOR USE WITH THE FACTORY
FULL LENGTH CENTER CONSOLE
TRIM ALONG INTERSECTION OF THE “STEP” IN THE PART AND THE PORTION
OF THE LINER THAT CONTINUES OVER THE HUMP. THIS WILL LEAVE A “LIP”
ON THE TRIMMED LINER AS SHOWN IN THE PHOTO BELOW.
6173FR~1.DOC
Rev: 0
09/20/00
Loading...