Husky Liners 6172 User Manual

THANK YOU FOR SELECTING A HUSKY FLOOR LINER

FROM WINFIELD CONSUMER PRODUCTS

CARE AND USE INSTRUCTIONS

Your new floor liners are custom molded to fit your particular vehicle. The liners are made to take the place of
your factory floor mats. For correct fit, it is necessary to remove the factory floor mats before installing your new
floor liners. However, do not remove the factory-installed carpeting.
Your liners are made from an engineering resin that is lightweight and extremely tough and durable. The easiest

way to clean your liners is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well. Use of
Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liners slick.

INSTALLATION INSTRUCTIONS FOR YOUR DODGE RAM

CLUB CAB TRUCK SECOND SEAT FLOOR LINER

JACK PLACEMENT VARIES SLIGHTLY WITH THE PRODUCTION DATE OF THE VEHICLE. TO INSTALL LINER, FIRST FOLD
UP THE REAR SEAT AND REMOVE THE JACK. THEN, TO DETERMINE WHICH SET OF RAISED JACK LOCATION BANDS TO
SLIT, TAKE NOTICE OF THE LEFT UPPERMOST JACK HOLD DOWN MOUNT (SHOWN ABOVE CIRCLED). IF THE MOUNT IS
APPROXIMATELY (2) INCHES IN FROM THE EDGE OF THE CARPET, MAKE A SLIT IN THE (3) RAISED AREAS THAT
APPEAR SHADED ON THE INSTRUCTION GUIDE. OTHERWISE, SLIT THE (3) UNSHADED RAISED AREAS SHOWN ON THE
INSTRUCTION GUIDE. YOU CAN ALSO NOTE WHICH LOCATION TO SLIT BY TEMPORARILY POSITIONING THE LINER IN
YOUR VEHICLE.

LEFT OR

PASSENGER’S

SIDE

FRONT OF VEHICLE

NOTE: DRIVER’S SIDE LINER

OVERLAPS PASSENGER SIDE

RIGHT OR
DRIVER’S

SIDE

6172.DOC
Rev: 0

02/01/01