Husky Liners 6160 User Manual

THANK YOU FOR SELECTING A HUSKY FLOOR LINER

FROM WINFIELD CONSUMER PRODUCTS

CARE AND USE INSTRUCTIONS

Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of your
factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your new floor
liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The easiest

way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well. Use of
Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liner slick.

INSTALLATION INSTRUCTIONS FOR YOUR CHEVROLET S-10/

GMC SONOMA/ISUZU HOMBRE SECOND SEAT FLOOR LINER

ALL S-10/SONOMA/HOMBRE TRUCKS EQUIPPED WITH A 2ND JUMP SEAT WILL REQUIRE
TRIMMING THE LINER ALONG THE RAISED RIB (SHOWN ABOVE RIGHT). TRIM ALONG THE
GROOVE IN THE CENTER OF THE RIB. OLDER MODEL VEHICLES MAY REQUIRE TRIMMING THE
TWO TRIM TABS (SHOWN ABOVE CENTER) TO ACCOMMODATE SEAT BELT MOUNTING
LOCATIONS. A UTILITY KNIFE WORKS WELL FOR TRIMMING.

6160.DOC
Rev: 0

02/01/01