Page 1
6143 front and back.doc
05/15/2006
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liners are custom molded to fit your particular vehicle. The liners are made to take the place of
your factory floor mats. For correct fit, it is necessary to remove the factory floor mats before installing your new
floor liners. However, do not remove the factory-installed carpeting.
Your liners are made from an engineering resin that is lightweight and extremely tough and durable. The
easiest way to clean your liners is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well.
Use of Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liners slick.
INSTALLATION INSTRUCTIONS FOR YOUR CHEVROLET SUBURBAN/
GMC YUKON XL SECOND SEAT FLOOR LINERS
IF YOUR VEHICLE IS EQUIPPED WITH THE OPTIONAL FRONT BUCKET SEATS AND CENTER CONSOLE,
YOU WILL NEED TO TRIM YOUR LINER TO ACHIEVE THE PROPER FIT ALONG THE BACK EDGE OF THE
CONSOLE. TO ADJUST FIT, SIMPLY TRIM AWAY THE MATERIAL ON THE CENTER HUMP PORTION OF THE
LINER THAT MATES UP TO THE CENTER CONSOLE (SEE DARKENED AREA IN DRAWING ABOVE). A TRIM
GROOVE IS MOLDED INTO THE LINER TO GUIDE TRIMMING. A UTILITY KNIFE OR HEAVY SHEARS WORK
WELL FOR TRIMMING. PHOTOS OF THE TRIMMED PART ARE SHOWN ON THE BACK OF THIS PAGE.
LEFT OR
DRIVER’S
SIDE
RIGHT OR
PASSENGER’S
SIDE
NOTICE: RIGHT LINER
OVERLAPS LEFT LINER
FRONT OF VEHICLE
Page 2
6143 front and back.doc
05/15/2006
PHOTOS OF PART #6143 TRIMMED FOR THE
CHEVROLET SUBURBAN/GMC YUKON XL
Loading...