Husky Liners 6077FR User Manual

THANK YOU FOR SELECTING A HUSKY FLOOR LINER

FROM WINFIELD CONSUMER PRODUCTS

CARE AND USE INSTRUCTIONS

Your new floor liners are custom molded to fit your particular vehicle. The liners are made to take the place of
your factory floor mats. For correct fit, it is necessary to remove the factory floor mats before installing your new
floor liners. However, do not remove the factory-installed carpeting.
Your liners are made from an engineering resin that is lightweight and extremely tough and durable. The easiest

way to clean your liners is with a damp cloth or sponge. If using a cleaner, 409® or Glass Plus® work well. Use of
Armor All®, Son-of-a-Gun® or similar items is discouraged as these products make the liners slick.

INSTALLATION INSTRUCTIONS FOR YOUR SECOND SEAT DODGE

DAKOTA QUAD CAB FLOOR LINERS

FRONT OF VEHICLE

LEFT OR

DRIVER’S

SIDE

NOTICE: RIGHT LINER
OVERLAPS LEFT LINER

IF YOUR QUAD CAB IS EQUIPPED WITH BUCKET SEATS, YOU MAY NEED TO TRIM YOUR LINER(S) TO
ALLOW FOR SEAT TRACK CLEARANCE DURING POSITIONING OF YOUR SEATS. INSTALL THE LINERS IN
YOUR VEHICLE AS DESCRIBED ABOVE MOVING YOUR SEATS THROUGH THEIR FULL RANGE OF POSITIONS.
IF INTERFERENCE OCCURS, TRIM YOUR LINERS AS NEEDED BY REMOVING THE MATERIAL IN THE RELIEF
AREA(S) PROVIDED ON YOUR LINERS (SEE ABOVE). TO TRIM, CUT AWAY THE OFFSET PORTIONS OF THE
RELIEF AREA(S) WHERE NEEDED (SEE PHOTO ON BACK). A UTILITY KNIFE OR HEAVY SCISSORS WORK
WELL FOR TRIMMING.

RIGHT OR

PASSENGER’S

SIDE

6077FR~1.DOC

Rev: 0

01/10/01

PHOTOS OF TRIMMED PART #6077

DRIVER’S SIDE

PART #6077 TRIMMED TO ACCOMMODATE

SEAT TRACK

PASSENGER’S SIDE

6077FR~1.DOC

Rev: 0

01/10/01