Page 1
PART NO. 5757
2003 LINCOLN NAVIGATOR FRONT OR REAR MUD GUARD SET
REAR MUD GUARD INSTALLATION INSTRUCTIONS
Please read instructions thoroughly before installation.
Tools Required:
• 1/8” drill bit / Drill
• Center punch / Hammer
• Short Phillips screwdriver
• Marking utensil (fine tip marker, grease pencil, etc.)
NOTE: Turn front wheels all the way left or right for installation. However, it may be necessary to remove the front or
rear wheels depending on the tools being used for installation.
1. Clean and degrease the mud guard location area on fender before installation.
2. Remove existing fastener from location A for FRONT mud guard installation (see Figure 1) or B for REAR mud
guard installation (see Figure 2).
3. Attach mud guard to front fender at location A or to rear fender at location B with existing fastener, check fit and
level before tightening (see Figure 1).
4. Using mud guard as a template, mark, center punch, drill 1/8” holes and attach with #10 screws at remaining mud
guard hole locations - B, C, D & E for front (Figure 1) and A, C, D, and E for rear (Figure 2).
Package Contents
• Driver & passenger side mud guard
• 1” #10 screws (qty. 8)
• Instruction sheet
PAINTING INSTRUCTIONS
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer
5757 Front_Rear…nstructions.doc
Rev: 0
Loading...