Husky Liners 5753 User Manual

PART NO. 5753

01-02 FORD F150 SUPERCREW WITHOUT FENDER FLARES

REAR MUD GUARD INSTALLATION INSTRUCTIONS

Please read instructions thoroughly before installation.

Tools Required

• 1/8” drill bit / Drill

• Short Phillips screwdriver

• Marking utensil (fine tip marker, grease pencil, etc.)

NOTE: It may be necessary to remove the rear wheels depending on the tools being used for installation.

Package Contents

• Driver & passenger side rear mud guard

• #10 screw (qty. 6)

• Instruction sheet

1. Clean and degrease the rear mud guard location area on the fender before installation.

2. Remove existing fastener from location B and attach mud guard at location B with factory fastener (Figure 1),
check fit and level before tightening.

3. Using the mud guard as a template, mark and drill 1/8” holes at locations A, C and D into fender.

4. Install #10 screws at locations A, C and D, through mud guard into fender (Figure 1).

PAINTING INSTRUCTIONS

1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.

2. Sand painting surface with 320 grit sand paper.

3. Apply a coating of flexible primer-adhesion promoter.

4. Apply a flexible paint as directed by the paint manufacturer.

5753 Rear Instructions .doc

Rev: 0