Page 1
PART NO. 5751
2001 FORD F150 SUPERCREW WITH FENDER FLARES
REAR MUD GUARD INSTALLATION INSTRUCTIONS
Please read instructions thoroughly before installation.
Tools Required
• 1/8” drill bit / Drill
• Short Phillips screwdriver
• Marking utensil (fine tip marker, grease pencil, etc.)
Package Contents
• Driver & passenger side rear mud guard
• #10 screw (qty. 6)
• Instruction sheet
1. Clean and degrease the mud guard location area on the fender before installation.
2. Using the mud guard as a template, mark and drill 1/8” holes at locations A, B and C into fender flare and fender.
3. Install #10 screws at locations A, B and C, through mud guard into fender flare and fender (Figure 1).
PAINTING INSTRUCTIONS
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer.
5751RE~1.DOC
Rev: 0
Loading...