PART NO. 5748
99-01 FORD EXCURSION LIMITED REAR MUD GUARD
INSTALLATION INSTRUCTIONS
Please read instructions thoroughly before installation.
Tools Required
• 1/8” drill bit / Drill
• Short #2 Phillips screwdriver
• Center punch
NOTE: It may be necessary to remove the rear wheels for mud guard installation.
1. Clean and degrease the mud guard location area on the fender before installation.
Package Contents
• Driver & passenger side rear mud guard
• #10 screw (qty. 8)
• U-Clip (qty. 2)
• Instruction sheet
2. Remove factory fastener from locations A and B (Figure 1).
3. Attach mud guard to rear fender with the factory fastener at location B, check fit and alignment. Adjust accordingly
before tightening.
4. Using the mud guard as a template, center punch and drill an 1/8” hole at location C and D (Figure 1).
5. Install a #10 screw at location C and D.
6. Install #10 screw at location A through the mud guard and fender and into a U-Clip (Figure 1 and 2).
NOTE: The U-Clip is used as a nut for the #10 screw and does not clip over the fender or liner panel.
PAINTING INSTRUCTIONS
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer.
5748RE~1.DOC
Rev: 0
Loading...