Husky Liners 57341 User Manual

PART NO. 5734

02 - 03 GMC ENVOY / ENVOY XL

REAR MUD GUARD INSTALLATION INSTRUCTIONS

Please read instructions thoroughly before installation.

Tools Required

• 1/8” drill bit / Drill

• Short Phillips screwdriver

• Marking utensil (fine tip marker, grease pencil, etc.)

• Center punch / Hammer

NOTE: It may be necessary to remove the rear wheels depending on the tools being used for installation.

Package Contents

• Driver & passenger side rear mud guard

• #10 screw (qty. 8)

• U-Clips (qty. 2)

• Instruction sheet

1. Clean and degrease the mud guard location area on the fender before installation.

2. Remove existing fastener from location A, and install mud guard with existing fastener at location A (Figure 1),
check fit and level before tightening.

3. Using mud guard as a template, mark, center punch, drill 1/8” holes and attach mud guard with #10 screws at
locations B and C.

4. Mark and drill an 1/8” hole on the fender liner at location D.

5. Install #10 screw at location D, through mud guard, fender liner and into a U-clip on the back side of the liner.

PAINTING INSTRUCTIONS

1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.

2. Sand painting surface with 320 grit sand paper.

3. Apply a coating of flexible primer-adhesion promoter.

4. Apply a flexible paint as directed by the paint manufacturer.

5734 Rear Instructions.doc

Rev: 0