Page 1
PART NO. 5729
95-02 GM S10 AND S15 TRUCK WITHOUT FENDER LIP MOLDING
95-97 GM S10 BLAZER AND S15 JIMMY WITHOUT FENDER LIP MOLDING
REAR MUD GUARD INSTALLATION INSTRUCTIONS
Please read instructions thoroughly before installation.
Tools Required
• 1/8” drill bit / Drill
• Short Phillips screwdriver
• Marking utensil (fine tip marker, grease pencil, etc.)
• Center punch / Hammer
NOTE: It may be necessary to remove the rear wheels depending on the tools being used for installation.
Package Contents
• Driver & passenger side rear mud guard
• #10 screw (qty. 8)
• Instruction sheet
1. Clean and degrease the mud guard location area on the fender before installation.
2. Using mud guard as a template, mark, center punch, and drill 1/8” hole at location A (Figure 1).
3. Attach mud guard to fender with #10 screws at location A, check fit and level before tightening.
4. Mark, center punch, and drill 1/8” holes at locations B, C, and D and install #10 screws.
PAINTING INSTRUCTIONS
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer.
5729 Rear Instructions.doc
Rev: 0
Loading...