Page 1
PART NO. 5727
98-02 GM S10 BLAZER/S15 JIMMY WITHOUT FENDER FLARES OR CLADDING
REAR MUD GUARD INSTALLATION INSTRUCTIONS
Please read instructions thoroughly before installation.
Tools Required
• 1/8” drill bit / Drill
• Short Phillips screwdriver
• Marking utensil (fine tip marker, grease pencil, etc.)
NOTE: It may be necessary to remove the rear wheels depending on the tools being used for installation.
Package Contents
• Driver & passenger side rear mud guard
• #10 screw (qty. 4)
• Instruction sheet
1. Clean and degrease the mud guard location area on the fender before installation.
2. Remove existing factory fasteners from location C (Figure 1).
3. Attach mud guard to fender with factory fastener at location C, check fit and level before tightening.
4. Using mud guard as a template, mark, center punch, and drill 1/8” holes at locations A & B (Figure 1).
5. Attach mud guard to fender with #10 screws at locations A & B.
PAINTING INSTRUCTIONS
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer.
5727 Rear Instructions.doc
Rev: 0
Loading...