PART NO. 5655
01-02 FORD ESCAPE WITH FENDER FLARES
FRONT MUD GUARD
INSTALLATION INSTRUCTIONS
Please read instructions thoroughly before installation.
Tools Required
• 1/8” drill bit / Drill
• Short Phillips screwdriver
• Marking utensil (fine tip marker, grease pencil, etc.)
NOTE: It may be necessary to remove the front wheels depending on the tools being used for installation.
1. Clean and degrease the mud guard location area on the fender before installation.
2. Place mud guard against front fender and using mud guard as a template mark and drill 1/8”
Package Contents
• Driver & passenger side front mud guard
• #10 screw (qty. 6)
• Instruction sheet
holes at locations A, B, and C (Figure 1).
3. Attach mud guard with #10 screws at locations A, B, and C, check fit and level before tightening.
PAINTING INSTRUCTIONS
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer
5655 Rear Instructions.doc
Rev: 0
Loading...