Page 1
PART NO. 5652
97-01 FORD EXPEDITION XLT WITHOUT FENDER FLARES
FRONT MUD GUARD INSTALLATION INSTRUCTIONS
Please read instructions thoroughly before installation.
Tools Required:
• 1/8” drill bit / Drill
• Short Phillips screwdriver
• Center punch
Package Contents
• Driver & passenger side mud guard
• #10 screw (qty. 8)
• Instruction sheet
NOTE: Turn the front wheels all the way to the left or right for mud guard installation. However, it may be necessary
to remove the wheels depending on the tools being used for installation.
1. Clean and degrease the mud guard location area on the fender before installation.
2. Remove factory fasteners from location B and C (see below).
3. Attach mud guard to front fender with the factory fasteners at location B and C, check fit and alignment. Adjust accordingly
before tightening.
4. Using the mud guard as a template, center punch, drill 1/8” hole, and install #10 screws at locations A and D into fender
5. Drill 1/8” hole and install #10 screws at location E and F into the fender liner.
PAINTING INSTRUCTIONS
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer.
5652FR~1.DOC
Rev: 0
Loading...