Husky Liners 5646 User Manual

Page 1
PART NO. 5646
96-01 FORD EXPLORER XLT with RUNNING BOARDS 96-97 FORD EXPLORER XLT without RUNNING BOARDS FRONT MUD GUARDS
INSTALLATION INSTRUCTIONS
Please read instructions thoroughly before installation.
1/8” drill bit / Drill
Center punch / Hammer
Short Phillips screwdriver
Marking utensil (fine tip marker, grease pencil, etc.)
Package Contents
Driver & passenger side mud guard
#10 screws (qty. 4)
Instruction sheet
NOTE: Turn the front wheels all the way to the left or right for mud guard installation. However, it may be necessary to remove the wheels depending on the tools being used for installation.
1. Clean and degrease the mud guard location area on the fender before installation.
2. Remove existing factory fasteners from locations B and C (Figure 1).
3. Attach mud guard to front fender with factory fasteners at locations B and C, check fit and level before tightening.
4. Using mud guard as a template, mark, center punch, and drill 1/8” hole at locations A and D (Figure 1).
5. Attach mud guard to fender with a #10 screws at locations A and D.
PAINTING INSTRUCTIONS
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer
5646 Front Instructions.doc
Rev: 0
Loading...