Husky Liners 5645 User Manual

PART NO. 5645

98-01 FORD EXPLORER w/o flares or running boards

FRONT MUD GUARD INSTALLATION INSTRUCTIONS

Please read instructions thoroughly before installation.

Tools Required:

• 1/8” drill bit / Drill

• Center punch / Hammer

• Short Phillips screwdriver

• Marking utensil (fine tip marker, grease pencil, etc.)

NOTE: Turn the front wheels all the way to the left or right for mud guard installation. However, it may be necessary
to remove the wheels depending on the tools being used for installation.

1. Clean and degrease the mud guard location area on the fender before installation.

2. Remove existing factory fasteners from locations B and C (Figure 1).

3. Attach mud guard to front fender with factory fasteners at locations B and C, check fit and level before tightening.

4. Using mud guard as a template, mark, center punch, and drill 1/8” holes at locations A, D, and E (Figure 1).

5. Attach mud guard to fender with a #10 screws at locations A, D, and E.

Package Contents

• Driver & passenger side mud guard

• #10 screws (qty. 6)

• Instruction sheet

PAINTING INSTRUCTIONS

1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.

2. Sand painting surface with 320 grit sand paper.

3. Apply a coating of flexible primer-adhesion promoter.

4. Apply a flexible paint as directed by the paint manufacturer

5645 Front Instructions.doc

Rev: 0