Page 1
PART NO. 5637
5637 Front_Rear Instr#1170B.doc
Rev: 0
CHEVROLET SS (SUPER SPORT) PU FRONT AND REAR MUD GUARDS
INSTALLATION INSTRUCTIONS
Please read instructions thoroughly before installation.
Tools Required:
• 1/8” drill bit / Drill
• Center punch / Hammer
• Short Phillips screwdriver or drill attachment
• Marking utensil (fine tip marker, grease pencil, etc.)
Package Contents:
• Driver & passenger side mud guards
• #10 screw (qty. 2)
• Washer (qty. 2)
• U-Clip (qty. 2)
• Instruction sheet
NOTE: Turn the front wheels all the way to the left or right for front mud guard installation. It may be necessary to remove the rear
wheels for rear mud guard installation. Clean and degrease the mud guard location areas on the fender before installation.
FRONT MUD GUARD INSTALLATION
1. Remove existing screw fasteners from locations A and B and remove plastic fastener from location C (Figure 1).
2. Pull the fender liner back and slide a U-Clip over fender sheet metal and existing hole at location C and replace liner.
3. Attach mud guard at locations A and B with existing screw fasteners. Adjust mud guard so that it is parallel with the ground
and covering the tire tread before tightening fasteners.
4. Install a # 10 screw and washer at location C thru mud guard, liner and into the u-clip.
REAR MUD GUARD INSTALLATION
5. Remove existing screw fasteners from locations A and B (Figure 2).
6. Attach mud guard at locations A and B with existing screw fasteners. Adjust mud guard so that it is parallel with the ground
and covering tire tread and tighten fasteners.
7. Using mud guard as a template, center punch, drill 1/8” hole, and fasten with a #10 screw at location C.
PAINTING INSTRUCTIONS
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer.
Loading...